ZyXEL Communications RS-1612 manual Control Card, 10Base2, 10Base5, 10Base-T

Page 20

10Base2, 10Base5, 10Base-T

These connectors are used to connect the RS-1612 to a LAN. ZyView can manage the RS-1612 via the LAN. Only one of the three connectors can be used at any time.

Control Card

An internal control card is installed to monitor and control the modems. The control card contains circuit and firmware for LCD control panel operation and is also used to download firmware using the RS-232 port on the back panel.

For details on upgrading your firmware refer to the Upgrading firmware section on page 24.

10

Image 20

Contents JiH5 ZyXEL Limited Warranty Acknowledgments FCC Part 15 InformationCopyright 1997 by ZyXEL Information for Canadian Users Declarations of CE marking Contacting ZyXEL ∙ E-mailVii Contents Setting up the RS-1612 Rack NMS Overview Configuring the RS-1612 rackControl Card RS-1612 Menu Tree 19 Rack Slot Menu 20 Modem MenuPage Introduction What This Manual CoversOther Resources Packing List∙ U-336R/RE Users Guide ∙ ZyViewII User’s Guide∙ One Menu Tree Guide ∙ One Warranty Registration Card Page Control Panel RS-1612 Control PanelPower Supply LEDs Rear Panel Fuse Pin Assignment Purpose DTE RS-232 PortsTerminal Blocks Power Switch DC Power TerminalsAC-DC switch Power SocketControl Card 10Base2, 10Base5, 10Base-TSetting up the RS-1612 Rack Modem CardPhone Lines Connecting to ComputersHooking Up Power Configuring the RS-1612 rack NMS OverviewSetting Rack Security NMS related CI commands Command DescriptionChecking the connection Nms mask add IP address mask and press EnterIP address configuration Command Description Page Operation RS-1612 Menu TreeRack Slot Menu Modem MenuMain Display Modem MenuMessage Display Contrast MenuSetting the RS-1612 Modem Reset MenuSetting the Display Contrast Resetting the Rack to its Default SettingsUpgrading firmware Unlocking a Rack Locked by a NMSSetting Modems Setting Modems with the Control Panel Resetting Modems to Factory DefaultsChanging Modem Cards