ZyXEL Communications manual NMS Overview, Configuring the RS-1612 rack

2.Replace the control panel.

3.Make sure all other hardware installations are complete.

4.Switch the power source selector on the back panel to AC or DC according to the type of power supply(s) you are using.

5.Plug one end of the power cord into the socket on the back panel.

6.Plug the other end to a properly rated power source.

7.Turn on the master power.

NMS Overview

The ZyXEL NMS consists of the RS-1612 rack and a PC running ZyView NMS software. Communication between the PC and the RS-1612 rack takes place via an IP based network which is linked by a LAN or a combination of LAN and WAN. ZyView identifies each RS-1612 rack by their assigned IP address. Using this dedicated IP address ZyView can send commands to and receive status reports from the rack.

2￿127(￿ ,)￿)25￿$1<￿5($621￿<28￿&+226(￿127￿72￿86(￿7+(￿=<9,(:￿106￿$1<￿6103 3/$7)250￿&$1￿%(￿86('￿72￿0$1$*(￿7+(￿5$&.￿

Configuring the RS-1612 rack

Follow the steps given below to configure your RS-1612 rack:

1.Use an RS-232 cable to connect the COM port of your computer to the DTE/RS-232 port of the rack.

2.From your terminal use a communications program such as Microsoft Hyper Terminal for Windows 95 to enter the data format as follows:

9600, N, 8, 1

13