Peavey PV 900, PV 2600, PV 1500 manual Important Safety Instructions

Page 3

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11.Only use attachments/accessories provided by the manufacturer.

12.Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Never break off the ground pin. Write for our free booklet “Shock Hazard and Grounding.” Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

16.If this product is to be mounted in an equipment rack, rear support should be provided.

17.Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government’s Occupational and Health Administration (OSHA) has specified the following permissible noise level exposures:

Sound Level dBA, Slow Response

Duration Per Day In Hours

8

90

6

92

4

95

3

97

3

Image 3
Contents S E R I E S a M P S Page Important Safety Instructions Introduction PV Series Stereo Power AmplifierInstallation Basic SetupPower Switch Front Panel FeaturesPower Leds PWR Signal Activity Leds SIGDomestic AC Mains Cord Back Panel FeaturesIEC Mains Connector Circuit BreakerFAN Grill Mode SwitchDDT Distortion Detection Technique Switch Speakon OutputsCombo Input Connector Industrial and Commercial InstallationsThru OUT Jacks DDT Bridge ModeRated Output Power SpecificationsPage Amplificateurs Proffessionnels Stereo PV Series DeballageMise EN Route Rapide Leds DDT Leds DE Signal SIGPanneau Avant Leds D’ALIMENTATIONPWRNe jamais déconnecter la connexion de terre de votre unité Panneau ArriereDisjoncteur Connecteur IECOuverture DE Ventilation Selecteur DE ModeSorties Speakon Selecteur DDT Distortion Detection TechniqueMode Pont Bridge Installations Industrielles ET CommercialesSpecifications Instalación Serie DE Amplificadores Profesionales Estéreo PVIntroducción DesempaqueInterruptor DE Corriente Funciones DEL Panel FrontalCable DE Corriente Domestico Para EE.UU Funciones DEL Panel TraseroBraker Conector Para Cable DE Corriente IECParrilla DEL Ventilador Salidas SpeakonCambio DE Modo Interruptor DDT Técnica DE Detección DE DistorsiónInstalaciones Industriales Y Comerciales Jacks DE Salida ThruErste Inbetriebnahme PV Series STEREO-ENDSTUFEEinleitung AuspackenFunktionen AN DER Vorderseite POWER-SCHALTERFunktionen AUF DER Rückseite 12 Lüftergitter SPEAKON-AUSGÄNGEMODE-SCHALTER DDT-SCHALTER Distortion Detection TechniqueInstallationen in Industrie UND Gewerbe COMBO-EINGANGSBUCHSENTHRU-OUT-KLINKEN BRIDGE-MODUS BRUMMEN/RAUSCHEN Peavey Electronics Corporation Limited Warranty