Peavey PV 1500, PV 900, PV 2600 manual Specifications

Page 17

Specifications

PV® 900

PV® 1500

PV® 2600

RATED OUTPUT POWER:

Stereo mode (EIA both channels driven) 2 ohms EIA, 1 kHz, 1% THD

4 ohms EIA, 1 kHz, 0.1% THD

8 ohms EIA, 1 kHz, 0.1% THD Bridge mode, mono

4 ohms EIA, 1 kHz, 1% THD

8 ohms EIA, 1 kHz, 0.1% THD

HUM & NOISE:

Stereo mode, below rated output power, 4 ohms

DISTORTION:

SMPTE-IM

INPUT SENSITIVITY & IMPEDANCE:

@rated output power, 4 ohms Balanced, TRS 1/4” phone jack Balanced, XLR (pin 2 positive) Overall system gain per channel

DISTORTION: (THD, typical value)

Stereo mode, both channels driven, 4 ohms 20 Hz to 20 kHz, 10 dB below rated power 20 Hz to 2 kHz, at full rated power

FREQUENCY RESPONSE:

Stereo mode, both channels driven +0, -1 dB @ 1 W RMS, 4 ohms +0, -3 dB @ rated output, 4 ohms

DAMPING FACTOR: (Typical value) Stereo mode, both channels driven 8 ohms, 1 kHz

POWER CONSUMPTION:

Stereo mode, both channels driven @ 1/8 rated output power, 4 ohms

TOPOLOGY:

WEIGHT:

FEATURE SET:

DDTCOMPRESSION ++:

COOLING SYSTEM:

INPUTS ++:

AMPLIFIER OUTPUTS:

LED INDICATORS ++:

AMP PROTECTION:

LOAD PROTECTION:

MAINS VOLTAGES AVAILABLE

DIMENSIONS:

450 W RMS/chan

750 W RMS/chan

1300 W RMS/chan

300 W RMS/chan

500 W RMS/chan

800 W RMS/chan

180 W RMS/chan

300 W RMS/chan

540 W RMS/chan

900 W RMS

1500 W RMS

2600 W RMS

600 W RMS

1000 W RMS

1800 W RMS

100 dB, unweighted

100 dB, unweighted

100 dB, unweighted

Less than 0.01%

Less than 0.01%

Less than 0.01%

0.87 V RMS(-1.2 dBV)

1.12 V RMS(+1dBV)

1.5 V RMS(+3.5 dBV)

10 K ohms per leg

10 K ohms per leg

10 K ohms per leg

10 K ohms per leg

10 K ohms per leg

10 K ohms per leg

40X (+32 dB)

40X (+32 dB)

40X (+32 dB)

Less than 0.03%

Less than 0.03%

Less than 0.03%

Less than 0.03%

Less than 0.03%

Less than 0.03%

20 Hz to 20 kHz

20 Hz to 20 kHz

20 Hz to 20 kHz

5 Hz to 50 kHz

5 Hz to 50 kHz

5 Hz to 50 kHz

Greater than 300

Greater than 300

Greater than 300

5.0 ARMS @ 120 VAC

7.0 ARMS @ 120 VAC

7.0 ARMS @ 120 VAC

Class AB

Class AB

Class H

40 lbs (18.2 kg)

45 lbs (20.5 kg)

49 lbs (22.3 kg)

All Models (++ indicates each channel)

Automatic, switchable with LED indicator Two-speed DC fan, air flow back to front

Electronic balanced; Barrier Strip, XLR, TRS 1/4" (6.3 mm) Speakons for Chan A, Chan B & Bridge; Binding Posts Red, DDT/clipping; Yellow, signal; Green, power

Full short circuit, open circuit; over-temp thermal; RF; stable into any load Turn on/off muting, DC (triac crowbar), low-cut filter

100, 120, 230, 240 VAC, 50-60 Hz

Height: 3.5” (8.9 cm), Width: 19" (48.3 cm), Depth: 15.5" (38.0 cm)

Les spécifications sont sujettes à modification sans avis préalable.

17

Image 17
Contents S E R I E S a M P S Page Important Safety Instructions Installation PV Series Stereo Power AmplifierBasic Setup IntroductionPower Leds PWR Front Panel FeaturesSignal Activity Leds SIG Power SwitchIEC Mains Connector Back Panel FeaturesCircuit Breaker Domestic AC Mains CordDDT Distortion Detection Technique Switch Mode SwitchSpeakon Outputs FAN GrillThru OUT Jacks Combo Input ConnectorIndustrial and Commercial Installations DDT Bridge ModeRated Output Power SpecificationsPage Mise EN Route Rapide Amplificateurs Proffessionnels Stereo PV SeriesDeballage Panneau Avant Leds DE Signal SIGLeds D’ALIMENTATIONPWR Leds DDTDisjoncteur Panneau ArriereConnecteur IEC Ne jamais déconnecter la connexion de terre de votre unitéSorties Speakon Selecteur DE ModeSelecteur DDT Distortion Detection Technique Ouverture DE VentilationMode Pont Bridge Installations Industrielles ET CommercialesSpecifications Introducción Serie DE Amplificadores Profesionales Estéreo PVDesempaque InstalaciónInterruptor DE Corriente Funciones DEL Panel FrontalBraker Funciones DEL Panel TraseroConector Para Cable DE Corriente IEC Cable DE Corriente Domestico Para EE.UUCambio DE Modo Salidas SpeakonInterruptor DDT Técnica DE Detección DE Distorsión Parrilla DEL VentiladorInstalaciones Industriales Y Comerciales Jacks DE Salida ThruEinleitung PV Series STEREO-ENDSTUFEAuspacken Erste InbetriebnahmeFunktionen AN DER Vorderseite POWER-SCHALTERFunktionen AUF DER Rückseite MODE-SCHALTER SPEAKON-AUSGÄNGEDDT-SCHALTER Distortion Detection Technique 12 LüftergitterTHRU-OUT-KLINKEN Installationen in Industrie UND GewerbeCOMBO-EINGANGSBUCHSEN BRIDGE-MODUS BRUMMEN/RAUSCHEN Peavey Electronics Corporation Limited Warranty