Lindy iSWITCH user manual Telnet Configuration

Page 25

Telnet Configuration

This section will guide you through finishing the configuration of the iSwitch using Telnet.

NOTE: You must complete the appropriate Setup Procedure before proceeding with the Telnet Configuration.

NOTE: You must have given the iSwitch an IP Address.

NOTE: The connection by telnet client limits only 2 users.

NOTE: Telnet client connects to CIC card will be timeout over 75 sec. The Ethernet cable is connected to the iSwitch and the iSwitch is on.

1.From the Desktop open the Start menu. Pick Programs and then open the MS-DOS Prompt.

2.This is an example. At the MS-DOS Prompt type telnet 192.166.7.19 (IP Address). Then hit enter.

3.Next you will be asked for the User Password. The default password is admin. Enter the password, then hit enter.

25

Image 25
Contents EPowerSwitch Table of Contents Trademarks Quick Install Procedure ISwitch-Front Panel ISwitch-Rear Panel Introduction ISwitch FeaturesSetup via the USB Port Requires Windows 98 or higher Setup ProcedurePage Page Page Page Page Page Page Page Setup via the Serial Port Page Page Page Page Page Setup via the Ethernet Port Page Telnet Configuration Page Page Page Page Web-Based Configuration Page ISP Mode PPP Mode Page Page ISwitch Name ID Address Configuration and IdentificationPage Page Page Firmware Upgrade Procedures Page Page Page Firmware upgrade is complete Telephone Access Interface Daisy Chaining Page Solution ProblemValue Purpose Subnet masking AppendixSubnet Mask Routing and Filtering Subnetting and Subnet MasksDry Closure AgentInput Dry Closure OutputObtaining Technical Assistance