Lindy iSWITCH user manual ISP Mode PPP Mode

Page 32

5.The PPP connection is useful if it is not possible to make a direct network connection to the iSwitch. An external modem is needed to connect to the front serial port of the iSwitch. The iSwitch support two ways using modem to connect directly.

ISP

After dialing in the remote user must hang up after the third ring. Based on the information that the user puts into the PPP configuration, the iSwitch will automatically dial up to the designated ISP and send an email to the designated email address with the assigned IP address from the ISP. The user may browse and control the iSwitch with this dynamic IP address. When the user is ready to exit click the "Disconnect Now " button at the bottom of the screen.

PPP

Both side are connected by modem.

NOTE: The user must complete one of the Setup Procedures and fill in all of the information in the PPP Configuration before the Dial- up Function will work.

ISP Mode

PPP Mode

32

Image 32
Contents EPowerSwitch Table of Contents Trademarks Quick Install Procedure ISwitch-Front Panel ISwitch-Rear Panel ISwitch Features IntroductionSetup Procedure Setup via the USB Port Requires Windows 98 or higherPage Page Page Page Page Page Page Page Setup via the Serial Port Page Page Page Page Page Setup via the Ethernet Port Page Telnet Configuration Page Page Page Page Web-Based Configuration Page ISP Mode PPP Mode Page Page ISwitch ID Address Configuration and Identification NamePage Page Page Firmware Upgrade Procedures Page Page Page Firmware upgrade is complete Telephone Access Interface Daisy Chaining Page Problem SolutionAppendix Value Purpose Subnet maskingSubnetting and Subnet Masks Subnet Mask Routing and FilteringAgent Dry ClosureInput Dry Closure OutputObtaining Technical Assistance