KTI Networks KPOE-800-2P, KPOE-800-1P manual Mounting two units in a rack

Page 11

2.Install the long bracket to the other side of the device.

3.Mount the device in a 19” rack.

Mounting two units in a rack

Use the bracket set 2 and follow the steps shown below: Short bracket x 4

Joint bracket x 1

1. Install two short brackets to both sides of each device.

2. Joint two units together as shown below:

Image 11

Contents Installation Guide Modular 8-Port Mid-span Power over Ethernet InjectorInternational United StatesTrademarks Table of Contents Introduction FeaturesMid-span Injector Function Product PanelsModel Definition SpecificationsPower Dissipation Power Module Slots LED IndicatorsPower Input Power ConsumptionUnpacking InstallationSafety Cautions Mounting one unit in a rack Mounting the InjectorDesktop Mounting Rack MountingMounting two units in a rack Unplug the AC power cord before any installation Installing Power ModuleSpecifications Applying AC PowerNetwork Cables Making Switch Port ConnectionsMaking LAN Connections Making Powered Device Connections Function State Interpretation LED IndicationShort-circuit Under voltageApplications Application with Low Power RequirementsApplication with High Power Requirements