IOGear M1057, GUIP204 manual Select Finish to complete the Found New Hardware Wizard

Page 17

8.Select Finish to complete the Found New Hardware Wizard.

9.Once you are finished with the Found New Hardware Wizard, the IOGEAR util- ity will show up and display all the active USB Net ShareStations connected on your network. In this screen, you will see the product listed as “IOGEAR GUIP204 – 567890 (192.168.10.59)”. The “567890” is the last 6 digits of the device’s MAC address, and the “192.168.10.59” is the device’s IP address.

Image 17

Contents Installation Guide Page Table of Contents Introduction About this Manual Features Package Contents Computer System RequirementsPhysical Description Hardware Installation Ethernet Reset Ethernet Software Installation XP Page Select No, not this time and click on Next to continue Click on Install the software automatically Select Finish to complete the Found New Hardware Wizard Connecting to a USB device Page Connecting to a USB Printer / Multifunction Printer Page Disconnecting a USB device If a USB device is being used by another Request to DisconnectPage Software Installation Vista Click on Finish to complete the installation process Page Page Page Page Page You are now ready to use the USB Net ShareStation Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Password Change FAQ Federal Communications Commission FCC Statement Page CE Statement Customer Support Limited Warranty IOGEAR, INC ContactPage FUN