IOGear GUIP204, M1057 manual Connecting to a USB Printer / Multifunction Printer

Page 20

Connecting to a USB Printer / Multifunction Printer

1.Connect the USB cable on your printer or multi function printer to the IOGEAR GUIP204 and make sure your printer is powered on. You will then see the connected printer show up in the IOGEAR Net ShareStation utility underneath the “IOGEAR GUIP204…” Select the printer from the list and click on the “Connect” button.

Note: If your USB device does not show up on the list, please try to disconnect and reconnect the device to the GUIP204. Also, please make sure the GUIP204 and your USB device are powered on.

20

Image 20
Contents Installation Guide Page Table of Contents Introduction About this Manual Features Package Contents System Requirements ComputerPhysical Description Hardware Installation Ethernet Reset Ethernet Software Installation XP Page Select No, not this time and click on Next to continue Click on Install the software automatically Select Finish to complete the Found New Hardware Wizard Connecting to a USB device Page Connecting to a USB Printer / Multifunction Printer Page Disconnecting a USB device Request to Disconnect If a USB device is being used by anotherPage Software Installation Vista Click on Finish to complete the installation process Page Page Page Page Page You are now ready to use the USB Net ShareStation Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Password Change FAQ Federal Communications Commission FCC Statement Page CE Statement Customer Support Limited Warranty Contact IOGEAR, INCPage FUN