IOGear M1057, GUIP204 manual

Page 27

5.Once the installation process has been completed you will need to go to the

Network window to configure the USB Net

ShareStation. To do so, click on the Vista logo on the lower right corner of your screen and select Network from the right hand side of the menu.

27

Image 27

Contents Installation Guide Page Table of Contents Introduction About this Manual Features Package Contents Computer System RequirementsPhysical Description Hardware Installation Ethernet Reset Ethernet Software Installation XP Page Select No, not this time and click on Next to continue Click on Install the software automatically Select Finish to complete the Found New Hardware Wizard Connecting to a USB device Page Connecting to a USB Printer / Multifunction Printer Page Disconnecting a USB device If a USB device is being used by another Request to DisconnectPage Software Installation Vista Click on Finish to complete the installation process Page Page Page Page Page You are now ready to use the USB Net ShareStation Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Password Change FAQ Federal Communications Commission FCC Statement Page CE Statement Customer Support Limited Warranty IOGEAR, INC ContactPage FUN