IOGear M1057, GUIP204 manual Connecting to a USB device in Vista

Page 33

Connecting to a USB device in Vista

1.After you have successfully installed the USB Net ShareStation driver, connect the USB cable of your USB device into the USB port on the USB Net ShareStation, and make sure both the USB device and the USB Net ShareStation are powered on.

2.When the USB device is connected, the USB Net ShareStation will detect the connection of the device, and an icon of the device will show up in the Network window. In this example, we have connected a Logitech USB speaker.

33

Image 33

Contents Installation Guide Page Table of Contents Introduction About this Manual Features Package Contents Computer System RequirementsPhysical Description Hardware Installation Ethernet Reset Ethernet Software Installation XP Page Select No, not this time and click on Next to continue Click on Install the software automatically Select Finish to complete the Found New Hardware Wizard Connecting to a USB device Page Connecting to a USB Printer / Multifunction Printer Page Disconnecting a USB device If a USB device is being used by another Request to DisconnectPage Software Installation Vista Click on Finish to complete the installation process Page Page Page Page Page You are now ready to use the USB Net ShareStation Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Password Change FAQ Federal Communications Commission FCC Statement Page CE Statement Customer Support Limited Warranty IOGEAR, INC ContactPage FUN