IOGear GUIP204, M1057 manual

Page 38

NOTE: after a system reboot, you might not be able to connect to any USB device for a short period of time. When right clicking on a device, you will see the following message instead of the option to “Connect.”

Depending on the performance of your PC and the number of active USB Net ShareStations on your network, it may take up to 3 minutes for your computer to recognize all USB Net ShareStation. This is because VISTA needs time to probe the entire network before it loads the necessary driver to run the USB Net ShareStation. Once the driver has been loaded, the option to “Connect” to the device will be made available when right-clicking a device.

38

Image 38
Contents Installation Guide Page Table of Contents Introduction About this Manual Features Package Contents System Requirements ComputerPhysical Description Hardware Installation Ethernet Reset Ethernet Software Installation XP Page Select No, not this time and click on Next to continue Click on Install the software automatically Select Finish to complete the Found New Hardware Wizard Connecting to a USB device Page Connecting to a USB Printer / Multifunction Printer Page Disconnecting a USB device Request to Disconnect If a USB device is being used by anotherPage Software Installation Vista Click on Finish to complete the installation process Page Page Page Page Page You are now ready to use the USB Net ShareStation Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Password Change FAQ Federal Communications Commission FCC Statement Page CE Statement Customer Support Limited Warranty Contact IOGEAR, INCPage FUN