IOGear GCS1732 user manual Connection for USB Computers

Page 15

Installation

4.Repeat steps 3 and 4 for any other computers you are connecting up.

5.Plug the power adapter cable into the switch’s Power Jack, then plug the power adapter into an AC power source.

6.Turn on the power to the computers.

(Connection for USB Computers)

(Connection for PS/2 Computers)

12

Image 15

Contents MiniView Extreme Page IOGEAR. All Rights Reserved. PKG-M0085 Table of Contents Package Contents Overview OverviewFeatures FeaturesAccessories RequirementsSystem Requirements Introduction Port Selection ButtonsPort LEDs Your USB keyboard and USB mouse plug in here USB Peripheral Section Firmware Upgrade SectionPower Jack Console Audio JacksCable Setup and Installation Before you Begin InstallationSetup and Installation Connection for USB Computers Powering Off and Restarting OperationHot Plugging Hot Key Operation Port ID NumberingAdvanced Hotkey Operations Basic Hotkeys to switch portsHotkey Mode Considerations Invoking Hotkey ModeOperation Operation Audio Port Selection Auto Scan ModeReverts back to Scroll Lock Scroll Lock Hotkey Beeper Control Hot Key Configuration for Mac and SUN Keyboard Emulation Sun Keyboard Hotkey Configuration for Mac and SUNMac Keyboard Firmware Upgrade Utility Firmware Upgrade Utility Starting the Upgrade Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Recovery Appendix TroubleshootingSpecification Specification Technical Support Radio & TV Interference Statement Limited Warranty Contact info