IOGear GCS1732 user manual Firmware Upgrade Utility

Page 29

The Firmware Upgrade Utility

4.Shut down the computers on your MiniView™ Extreme installation and make sure the firmware upgrade switch is set to “Upgrade”.

5.Make sure the power plugged into the KVM.

6.Once the power is plugged in and the switch is set to upgrade, all of the amber lights on the KVM will flash once per second. Now you are ready to run the firmware upgrade utility.

26

Image 29
Contents MiniView Extreme Page IOGEAR. All Rights Reserved. PKG-M0085 Table of Contents Package Contents Overview OverviewFeatures FeaturesSystem Requirements AccessoriesRequirements Port LEDs IntroductionPort Selection Buttons Your USB keyboard and USB mouse plug in here Power Jack Firmware Upgrade SectionConsole Audio Jacks USB Peripheral SectionCable Setup and Installation Before you Begin InstallationSetup and Installation Connection for USB Computers Hot Plugging Powering Off and RestartingOperation Hot Key Operation Port ID NumberingAdvanced Hotkey Operations Basic Hotkeys to switch portsHotkey Mode Considerations Invoking Hotkey ModeOperation Operation Audio Port Selection Auto Scan ModeReverts back to Scroll Lock Scroll Lock Hotkey Beeper Control Hot Key Configuration for Mac and SUN Keyboard Emulation Sun Keyboard Hotkey Configuration for Mac and SUNMac Keyboard Firmware Upgrade Utility Firmware Upgrade Utility Starting the Upgrade Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Utility Firmware Upgrade Recovery Appendix TroubleshootingSpecification Specification Technical Support Radio & TV Interference Statement Limited Warranty Contact info