Kramer Electronics VS-84H user manual ETH Reset Button

Page 10

Defining the VS-84H 8x4 HDMI Matrix Switcher

Figure 2: VS-84H 8x4 HDMI Matrix Switcher Rear Panel

Table 2: VS-84H 8x4 HDMI Matrix Switcher Rear Panel Features

#

Feature

 

 

Function

13

OUT HDMI Connectors (1 to 4)

Connect to up to 4 HDMI acceptors

14

IN HDMI Connectors (1 to 8)

Connect to up to 8 HDMI sources

15

RS-2329-pin D-sub Serial Port

Connect to a PC/serial controller

 

Connector

 

 

 

16

ETHERNET RJ-45 Connector

Connect to a PC via a LAN

17

ETH RESET Button

Press to reset to the factory default IP parameters1

18

REMOTE IR Opening2

Connect to an external IR receiver for controlling the device via an IR remote controller (see

 

 

 

Section 4.1)

 

 

 

 

 

19

Mains Power Connector

Connect to the mains power

20

Mains Power Fuse

Fuse for protecting the device

21

Mains Power Switch

Switch for turning the device on or off

1 First turn the VS-84H off and then turn it on again while pressing the ETH RESET button. The device will power up and load its memory with the factory default IP parameters 2 Covered by a cap. The 3.5mm jack at the end of the internal IR connection cable fits into this opening

7

Image 10 Contents
Model Contents FiguresTables Introduction Getting StartedKramer Simple Creative Technology Overview Defining the EdidAbout Hdmi About HdcpDefining the VS-84H 8x4 Hdmi Matrix Switcher Recommendations for Best PerformanceFeature Function ETH Reset Button Using the IR Transmitter Installing the VS-84H in a Rack Connecting the VS-84H 8x4 Hdmi Matrix Switcher Connecting the VS-84H 8x4 Hdmi Matrix SwitcherSwitching an Input to an Output Operating the VS-84H 8x4 Hdmi Matrix SwitcherAcquiring the Edid Acquiring the Edid from Several Outputs Storing and Recalling a Switching Setting from a Preset Connecting to the VS-84H 8x4 Hdmi Matrix Switcher via RS-232Select Properties Upgrading the Firmware Internet Protocol TCP/IP Properties WindowTechnical Specifications Default EdidDefault Edid Detailed timing #5 1280x720p at 50Hz Default Communication Parameters Default Communication ParametersKramer Protocol Protocol DefinitionsInstruction Codes for Protocol 82 ie. request the number of outputs Only the first purchase customer may enforce this warranty SePPKPPPcSS