Linksys USB100H1 manual Overview, Installing the USB Network Adapter & Cabling

Linksys HomeLink™ Series

Installing the Phoneline +

10/100 USB Network

Adapter

Overview

The following instructions will help you physically connect your computer to your network through your Phoneline + 10/100 USB Network Adapter. After you physically install the adapter, you have to then install the adapter’s driver software onto your computer and configure your computer to access your net- work. Driver installation and PC configuration instructions follow these device installation instructions.

Keep in mind that the USB Network Adapter will only support one network media type at a time. The adapter can not connect any device to a Phoneline network and an Ethernet network at the same time.

Installing the USB Network Adapter & Cabling

1.Insert the cable’s type B plug into the adapter’s B-type port.

Note: USB cabling and port information can be found on pages 3-5.

2.Insert the other end of the USB cable (the type A connector) into the USB port on your PC.

Your computer is now connected to your USB Network Adapter.

Continue onto the next page to connect your computer to a Phoneline network, or go to page 8 to connect it to an Ethernet or Fast Ethernet network.

6