Linksys EG1032 V3 manual Vlan

Page 30

10/100/1000 Gigabit Network Adapter

VLAN

The VLAN screen shows all VLANs established on the Adapter. VLAN ID is used when setting up virtual LANs on your network. By assigning the ID, this PC will access other PCs within the VLAN. Up to 4,096 VLANs can be identified by the Adapter.

The VLAN screen also allows you to add a VLAN, by clicking the Add button. You can also delete a VLAN, by clicking the Delete button, and modify and VLAN ID, by clicking the Modify VID button.

Driver

Figure 9-5: The Utility’s VLAN screen

The Driver screen shows general information about the Adapter’s driver, including what version is running, the version number, when it was installed, as well as other information. By clicking the + symbol to the left of Driver in the menu, you can open the Advanced Settings screen.

The Advanced Settings screen is intended for Advanced users only and contains the following settings: 802.1p/Q

Tagging, Flow Control, Jumbo Frame, Linksys Speed/Duplex Mode, Network Address, Offload Checksum, Offload

TCP_Large Send.

Figure 9-6: The Utility’s Driver screen

802.1p/Q Tagging

Enabling this feature allows for quality of service packet tagging when connected to a network switch that supports quality of service. Therefore, this feature should only be enabled when connecting to such a switch. If connecting to a switch that does not support quality of service, disable this feature. To save your modifications of this feature, click the Modify button.

Figure 9-7: The Utility’s Driver - 802.1p/Q Tagging - screen

Chapter 9: Using the EG1032 Instant Gigabit Network Adapter Diagnostic Utility

23

Using the Diagnostic Utility

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Gigabit How to Use this User Guide Copyright and TrademarksTable of Contents Appendix a Troubleshooting Common Problems and SolutionsList of Figures Port and LEDsGeneral Tab for Windows XP or 16 The Utility’s Statistics screen Introduction What’s in this Guide?Introduction What’s in this Guide? Getting to Know the 10/100/1000 Gigabit Network Adapter Adapter’s port and LEDs are located on the metal panelHardware Installation Insert the Adapter into the PCI SlotInstalling the Driver for Windows XP Installing the DriverOverview Driver Installation Complete Uninstalling the Adapter Confirm Device RemovalInstalling the Driver for Windows Install Hardware Device DriversDriver Location Installing the Driver for Windows Uninstalling the Adapter Installing the Driver for Windows Millennium or 98SE Add New Hardware WizardRestart Computer Device Manager for Windows Me or 98SE Accessing the Adapter’s Configuration Adapter ConfigurationGeneral Advanced DriverPower Management ResourcesGeneral Tab for Windows Me or 98SE Driver Tab for Windows Me or 98SE Power Management Tab for Windows Me or 98SE Installing the Diagnostic Utility Welcome ScreenInstallShield Wizard Complete Using the Diagnostic Utility Utility’s IconVlan Utility’s Driver Flow Control screen 13 The Utility’s Driver Offload TCPLarge Send screen Diagnostics StatisticsCable Wake on LANAppendix a Troubleshooting Common Problems and SolutionsRestart your computer Network Neighborhood is empty 10/100/1000 Gigabit Network Adapter Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix C Glossary 10/100/1000 Gigabit Network Adapter 10/100/1000 Gigabit Network Adapter Appendix D Specifications ModelPort Appendix E Warranty Information Limited WarrantyAppendix F Regulatory Information FCC StatementAppendix G Contact Information
Top Page Image Contents