Linksys EG1032 V3 manual Cable, Wake on LAN

Page 34

10/100/1000 Gigabit Network Adapter

Cable

The Cable screen will display the length and status of the network cable attached to the adapter. Cable status is displayed as follows:

Normal - The cable is connected and functioning normally.

Open - The cable is either not connected or not functioning properly.

Short - There is a short in the cable.

The Cable screen provides information about the Cable analysis is invalid in 10 Mbps speed.

Figure 9-17: The Utility’s Cable screen

Wake on LAN

Wake on LAN allows you to remotely wake up your PC, after it has gone into “Sleep Mode”, from anywhere on the network. The Wake on LAN screen allows you to perform Wake on LAN on any PC equipped with the Adapter and using the Utility. Enter either the PC’s Ethernet (or MAC) address, IP address, or NetBIOS name, and click the Wake Up button.

Figure 9-18: The Utility’s Wake on LAN screen

Chapter 9: Using the EG1032 Instant Gigabit Network Adapter Diagnostic Utility

27

Using the Diagnostic Utility

Image 34

Contents Gigabit How to Use this User Guide Copyright and TrademarksTable of Contents Appendix a Troubleshooting Common Problems and SolutionsList of Figures Port and LEDsGeneral Tab for Windows XP or 16 The Utility’s Statistics screen Introduction What’s in this Guide?Introduction What’s in this Guide? Getting to Know the 10/100/1000 Gigabit Network Adapter Adapter’s port and LEDs are located on the metal panelHardware Installation Insert the Adapter into the PCI SlotInstalling the Driver Installing the Driver for Windows XPOverview Driver Installation Complete Uninstalling the Adapter Confirm Device RemovalInstalling the Driver for Windows Install Hardware Device DriversDriver Location Installing the Driver for Windows Uninstalling the Adapter Installing the Driver for Windows Millennium or 98SE Add New Hardware WizardRestart Computer Device Manager for Windows Me or 98SE Adapter Configuration Accessing the Adapter’s ConfigurationGeneral Advanced DriverPower Management ResourcesGeneral Tab for Windows Me or 98SE Driver Tab for Windows Me or 98SE Power Management Tab for Windows Me or 98SE Installing the Diagnostic Utility Welcome ScreenInstallShield Wizard Complete Using the Diagnostic Utility Utility’s IconVlan Utility’s Driver Flow Control screen 13 The Utility’s Driver Offload TCPLarge Send screen Diagnostics StatisticsCable Wake on LANAppendix a Troubleshooting Common Problems and SolutionsRestart your computer Network Neighborhood is empty 10/100/1000 Gigabit Network Adapter Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix C Glossary 10/100/1000 Gigabit Network Adapter 10/100/1000 Gigabit Network Adapter Model Appendix D SpecificationsPort Appendix E Warranty Information Limited WarrantyAppendix F Regulatory Information FCC StatementAppendix G Contact Information