STEP 3-Connecting the Power Cable
Connections on underside
Power
Power switch
Power cable
Depending on where you live, you will use either the European or US/Canadian power cable.
•Connect the female end of the power cable to the Brick power supply.
•Connect the Brick power supply into the power port on the touchmonitor.
To protect your equipment against risk of damage from electrical surges in the power line, plug the brick supply’s power cord into a surge protector, and then connect the surge protector to a grounded
•Power on your PC then your touchmonitor. After a brief pause the picture should appear.
•The power can be turned on and off by the small white switch on the back of the touchmonitor. The touchmonitor can also be turned on and off by plugging and unplugging the power cable.
Optimizing the LCD Display
To ensure the LCD display works well with your computer, configure the display mode of your graphic card to output 1024 x 768 resolution, and make sure the timing of the display mode is compatible with the LCD display. Refer to Appendix A for more information about resolution. Compatible video modes for your touchmonitor are listed in Appendix C. Refer to Chapter 3 for more information on adjusting your touchmonitor’s video characteristics.