
Return to Section TOC
Return to Master TOC
B-6 OPERATIONB-6
FIGURE B.2 – READI-REEL® INSTALLATION.
2" O.D. | MOLDED ADAPTER | |
SPINDLE | ||
| ||
| RETAINING | |
| SPRING |
THREAD LOCKING
TOC
TOC
BRAKE HOLDING PIN (MUST ENGAGE HOLE IN ADAPTER RIB)
COLLAR
Return to Section
Return to Master
GROOVES
READI-REEL
INSIDE CAGE
WIRES
Section TOC
Master TOC
LOADING WIRE DRIVE
a. Turn the reel or spool until the free end of the electrode is accessible.
b. While tightly holding the electrode, cut off the bent end and straighten the first six inches. Cut off the first inch. (If the electrode is not properly straightened, it may not feed or may not go into the outgoing guide tube causing a “birdnest”.)
c. Insert the free end through the incoming guide tube to the drive roll.
f.Inch the electrode through the gun.
g.Adjust the brake tension with the thumbscrew on the spindle hub until the reel turns freely, but with little or no overrun when wire feeding is stopped. Do not over tighten.
CAUTION
Keep gun in
Return to
TOC
Return to
d. Turn on the welding power source.
WARNING
Unless an optional output control or internal contactor is used with the
e. Press the gun trigger and push the electrode until it just enters the drive roll.
IDLE ROLL PRESSURE SETTING
The idle roll pressure is set at the factory backed out two turns from full pressure. This is an approximate setting. For small wire sizes and aluminum wire, the optimum idle roll pressure varies with type of wire, surface condition, lubrication and hardness. The op- timum idle roll setting can be determined as follows:
1.Press end of gun against a solid object that is electrically isolated from the welder output. Press the gun trigger for several seconds.
Return to Section
Return to Master TOC
WARNING
When inching with gun trigger, the electrode and drive mechanism are always “hot” to work and ground. Use the “cold” inch switch on models with internal contactor.
2.If the wire “birdnests,” jams or breaks at the drive roll, the idle roll pressure is too great. Back the pressure setting out 1⁄2 turn, run new wire through gun, and repeat above steps.
3.If the only result is drive roll slippage, shut off the power source, then loosen the gun cable clamping