Elo TouchSystems 15A1 manual Test Devices, Testing the Touchscreen, Calibration

Page 14

Test Devices

The touchcomputer can be pre-installed with several different hardware options. To test an optional device that is installed on the touchcomputer, follow the instructions below.

NOTE: Testing icons are located on the desktop. Testing of a particular device can only be done after the device is properly installed.

Testing the Touchscreen

The touchscreen is pre-calibrated for accurate touch response.

Calibration*

If for any reason the touchscreen needs to be re-calibrated, double-click the Touchscreen- Test icon. The window shown below will open.

Click on the Align button. This launches the calibration program. The window shown below will open. Follow the instructions to calibrate the touchscreen.

*Calibration may not be applicable for all touch technologies.

Elo TouchSystems 15A1 User Guide 14

Image 14

Contents Touchcomputer User Guide Revision C E362310 Elo TouchSystems Elo TouchSystems Touchcomputer User GuideLCD Multifunction Touchcomputer Copyright 2008 Tyco Electronics. All Rights Reserved DisclaimerTable of Contents Regulatory Information Warranty Setup Unpacking Your TouchcomputerProduct Overview Front View Rear ViewSide View Base Bottom View Display Orientation Display Orientation with Peripherals Initial Turn-On Language SelectionPage Time-zone selection Calibration Testing the TouchscreenTest Devices Testing in USB MSR Human Interface Device HID Mode Testing the Magnetic Stripe Reader MSR optionalTesting in USB MSR Keyboard KB Emulation Mode Converting MSR from Keyboard Emulation to HID and vice versa Testing the Customer Display optional Testing the Cash Drawer PortOperation OSD Control OSD MenuTo lock the OSD OSD LockoutShortcut keys To unlock the OSDPower Lockout Power ControlPower Button To lock the PowerUsing the I/O panel PS/2 Universal KensingtonTM LockSecuring the Touchcomputer Base Base Bottom View Mounting PatternDisplay Angle Upgrades Adding PeripheralsMaintenance Care and Handling of Your Touchcomputer Waste Electrical and Electronic Equipment Weee DirectiveTo Install Hard Disk Drive Servicing the Hard Disk DriveRecovering the Operating System Technical Specifications Touchcomputer Specifications RAMPage RS485 Mode Pin Definitionfor COM2 only COM1, COM2 ConnectorRS232 ModeRS422 Mode Pin Definitionfor COM2 only Power Input Pin Definition RJ45 connector Pin DefinitionDB9 connector Pin Definition Cash Drawer Port Signal Definition and Control ControlPage Page Display Specifications Display ModePower Supply Specifications Touchscreen Specifications Customer Display Peripherals SpecificationsMagnetic Stripe Reader MSR USB VersionEnvironmental Specifications Temperature RangesTechnical Support Using the TouchcomputerUsing the Web Using the Phone Technical AssistanceII. Emissions and Immunity Information Electrical Safety InformationRegulatory Information Page III. Safety Label Warranty Page Check out Elo’s Website