Elo TouchSystems 15A1 manual Touchcomputer Specifications, Ram

Page 32

Touchcomputer Specifications

Note: Not all operating systems or options are supported in all regions.

Please contact your local Elo TouchSystems representative for details.

Processor

Intel Celeron M 1.0GHz CPU w/400MHz Front-Side Bus

RAM

512 MB DDR2 RAM standard. Up to 1.5GB

Northbridge

Intel 915GME

Southbridge

Intel ICH6

Video

Intel GMA 900 Up to 128MB shared w/ DVMT

Operating systems

Microsoft Windows XP Professional

 

Microsoft Windows Embedded for Point of Service (WEPOS)

Ports

4 x USB 2.0 ports

 

1 x 12V powered USB 2.0 port

 

1 x 12V cash drawer port

 

1 x 10/100 Base-T ethernet port

 

2 x Serial ports (RJ connector)

 

COM1, RS232, COM2 selectable RS232/RS422/RS485

 

1 x Microphone input 3.5mm

 

1 x Audio Output 3.5mm

 

1 x VGA output

 

1 x PS/2 Universal

BIOS

ACPI 2.0,APM 1.2, SMBIOS 2.4, PXE, WOL

Real Time clock

Replaceable lithium-ion battery for clock

Storage

XP/WEPOS: 40 GB HDD(minimum)

 

Power supply

Type: External brick

 

 

Input (line) voltage: 100-240 VAC, 50-60 Hz

 

Output voltage/current: 12 V at 10 amps max.

 

120 watts minimum

Power dissipation

100 W Typical

 

 

Temperature

Operating: 0oC to 35oC

 

Storage: -20oC to 60oC

Humidity

Operating: 20%-80%

 

Storage: 5%-95%

 

noncondensing

 

 

 

Elo TouchSystems 15A1 User Guide 32

Image 32
Contents Touchcomputer User Guide Revision C E362310 Elo TouchSystems Elo TouchSystems Touchcomputer User GuideLCD Multifunction Touchcomputer Copyright 2008 Tyco Electronics. All Rights Reserved DisclaimerTable of Contents Regulatory Information Warranty Setup Unpacking Your TouchcomputerProduct Overview Front View Rear ViewSide View Base Bottom View Display Orientation Display Orientation with Peripherals Initial Turn-On Language SelectionPage Time-zone selection Calibration Testing the TouchscreenTest Devices Testing in USB MSR Human Interface Device HID Mode Testing the Magnetic Stripe Reader MSR optionalTesting in USB MSR Keyboard KB Emulation Mode Converting MSR from Keyboard Emulation to HID and vice versa Testing the Customer Display optional Testing the Cash Drawer PortOperation OSD Control OSD MenuOSD Lockout Shortcut keysTo lock the OSD To unlock the OSDPower Control Power ButtonPower Lockout To lock the PowerUsing the I/O panel PS/2 Universal KensingtonTM LockSecuring the Touchcomputer Base Base Bottom View Mounting PatternDisplay Angle Upgrades Adding PeripheralsMaintenance Care and Handling of Your Touchcomputer Waste Electrical and Electronic Equipment Weee DirectiveTo Install Hard Disk Drive Servicing the Hard Disk DriveRecovering the Operating System Technical Specifications Touchcomputer Specifications RAMPage RS485 Mode Pin Definitionfor COM2 only COM1, COM2 ConnectorRS232 ModeRS422 Mode Pin Definitionfor COM2 only Power Input Pin Definition RJ45 connector Pin DefinitionDB9 connector Pin Definition Cash Drawer Port Signal Definition and Control ControlPage Page Display Specifications Display ModePower Supply Specifications Touchscreen Specifications Peripherals Specifications Magnetic Stripe Reader MSRCustomer Display USB VersionEnvironmental Specifications Temperature RangesUsing the Touchcomputer Using the Web Using the PhoneTechnical Support Technical AssistanceII. Emissions and Immunity Information Electrical Safety InformationRegulatory Information Page III. Safety Label Warranty Page Check out Elo’s Website