Elo TouchSystems 15A1 manual Using the I/O panel

Page 22

Using the I/O panel

The touchcomputer provides the following I/O interfaces for connecting a wide variety of compliant devices.

USB and Powered USB

There are four USB 2.0 type A ports, including one 12V powered USB 2.0 port.

Cash Drawer

There is one 12V cash drawer port with a six position register jack connector interface. For additional information, see the Cash Drawer Port Signal Definition and Control section on page 36.

Ethernet

There is one RJ45 ethernet port providing LAN capabilities

Serial

There are two serial ports with an 8 position registered jack connector interface. COM1 is set to RS232 mode. COM2 is selectable in the BIOS to RS232, RS422 or RS485 modes. Use the supplied DB9 adapter cable to change the interface to DB9.

Microphone Input

There is one 3.5mm microphone input jack for connecting an external microphone

Audio Output

There is one 3.5mm stereo audio output jack for connecting headphones or external powered speakers.

Elo TouchSystems 15A1 User Guide 22

Image 22

Contents Touchcomputer User Guide LCD Multifunction Touchcomputer Elo TouchSystems Touchcomputer User GuideRevision C E362310 Elo TouchSystems Copyright 2008 Tyco Electronics. All Rights Reserved DisclaimerTable of Contents Regulatory Information Warranty Setup Unpacking Your TouchcomputerProduct Overview Front View Rear ViewSide View Base Bottom View Display Orientation Display Orientation with Peripherals Initial Turn-On Language SelectionPage Time-zone selection Test Devices Testing the TouchscreenCalibration Testing in USB MSR Keyboard KB Emulation Mode Testing the Magnetic Stripe Reader MSR optionalTesting in USB MSR Human Interface Device HID Mode Converting MSR from Keyboard Emulation to HID and vice versa Testing the Customer Display optional Testing the Cash Drawer PortOperation OSD Control OSD MenuTo lock the OSD OSD LockoutShortcut keys To unlock the OSDPower Lockout Power ControlPower Button To lock the PowerUsing the I/O panel PS/2 Universal KensingtonTM LockSecuring the Touchcomputer Base Base Bottom View Mounting PatternDisplay Angle Upgrades Adding PeripheralsMaintenance Care and Handling of Your Touchcomputer Waste Electrical and Electronic Equipment Weee DirectiveTo Install Hard Disk Drive Servicing the Hard Disk DriveRecovering the Operating System Technical Specifications Touchcomputer Specifications RAMPage RS422 Mode Pin Definitionfor COM2 only COM1, COM2 ConnectorRS232 ModeRS485 Mode Pin Definitionfor COM2 only DB9 connector Pin Definition RJ45 connector Pin DefinitionPower Input Pin Definition Cash Drawer Port Signal Definition and Control ControlPage Page Display Specifications Display ModePower Supply Specifications Touchscreen Specifications Customer Display Peripherals SpecificationsMagnetic Stripe Reader MSR USB VersionEnvironmental Specifications Temperature RangesTechnical Support Using the TouchcomputerUsing the Web Using the Phone Technical AssistanceRegulatory Information Electrical Safety InformationII. Emissions and Immunity Information Page III. Safety Label Warranty Page Check out Elo’s Website