Enter a Logo PIN code, Change the Logo PIN code

Setting

Logo PIN code lock

This function prevents an unauthorized person from changing the screen logo.

Off . . The screen logo can be changed freely from the Logo Menu.

On . . The screen logo cannot be changed without a Logo PIN code.

If you want to change the Logo PIN code lock setting, press the OK button and the Logo PIN code dialog box appears. Enter a Logo PIN code by following the steps below. The initial Logo PIN code is set to “4321” at the factory.

Enter a Logo PIN code

Use the Point ed buttons on the side control or Number buttons on the remote control unit to enter a number.

When using side control

Use the Point ed buttons on the side control to select a number. Press the Point 8 button to fix the number and move the red frame pointer to the next box. The number changes to “✳.” Repeat this step to complete entering a four-digit number. After entering the four-digit number, move the pointer to “Set.” Press the OK button so that you can change the Logo PIN code lock setting.

When using remote control unit

Press the Number buttons on the remote control unit to enter a number (p.14). When you complete entering a four-digit number, the pointer moves to “Set.” Press the OK button so that you can change the Logo PIN code lock setting.

If you fixed an incorrect number, use the Point 7 button to move the pointer to the number you want to correct, and then enter the correct number.

If you entered an incorrect PIN code, “Logo PIN code” and the number (✳✳✳✳) will turn red for a moment. Enter the correct PIN code all over again.

Change the Logo PIN code lock setting

Use the Point 7 8 buttons to switch On/Off, and then press the Point d button to move the pointer to “Quit.” Press the OK button to close the dialog box.

Change the Logo PIN code

Logo PIN code can be changed to your desired four-digit number. Press the Point d button to select “Logo PIN code change” and then press the OK button. The New Logo PIN code input dialog box appears. Set a new Logo PIN code.

Be sure to note the new Logo PIN code and keep it at hand. If you lost the number, you could no longer change the Logo PIN code setting. For details on PIN code setting, refer to “PIN code lock” on pages 53–54.

Logo PIN Code Lock

Enter a Logo PIN code

After a correct Logo PIN code is entered, the following dialog box appears.

Change the Logo PIN code lock setting

Use the Point 7 8 buttons to switch On/Off,

Change the Logo PIN code

caution:

when you have changed THE LOGO PIn code, write down the new pin code in column of the LOGO pin code no.. memo on page 76, and keep it securely.. should the LOGO pin code be lost or forgotten,the LOGO pin code setting can no longer be changed..

NOTE:

If you forget your Logo PIN code and unable to change it, the Logo PIN code can be reset to the factory default setting (4321) according to the following procedures.

When you reset the Logo PIN code, the PIN code and Key lock will be reset, as well.

1.Unplug the AC Power Cord from the AC outlet.

2.Hold down the OK button on the projector and connect the AC Power Cord into the outlet again. Keep holding down the OK button until the POWER indicator lights. The Logo PIN code returns to the factory default setting while the Logo PIN code lock state will remain the same as the previous set state.