Change the PIN Code Lock setting, Enter a PIN code

Setting

Enter a PIN code

Use the Point ed buttons on the side control or Number buttons on the remote control unit to enter a number.

When using side control

Use the Point ed buttons on the side control to select a number. Press the Point 8 button to fix the number and move the red frame pointer to the next box. The number changes to “✳.” Repeat this step to complete entering a four-digit number. After entering the four-digit number, move the pointer to “Set.” Press the OK button so that you can change the PIN code lock setting.

When using remote control unit

Press the Number buttons on the remote control unit to enter a number (p.14). When you complete entering a four-digit number, the pointer moves to “Set.” Press the OK button so that you can change the PIN code lock setting.

If you fixed an incorrect number, use the Point 7 button to move the pointer to the number you want to correct, and then enter the correct number.

If you entered an incorrect PIN code, “PIN code” and the number (✳✳✳✳) will turn red for a moment. Enter the correct PIN code all over again.

Change the PIN Code Lock setting

Use the Point 7 8 button to select Off, On1, or On2 and then move the pointer to “Quit” with the Point d button. Press the OK button to close the dialog box.

Change the PIN Code

The PIN code can be changed to your desired four-digit number. Press the Point d buttons to select “PIN code change” and press the OK button. The New PIN code input dialog box appears. Set a new PIN code.

caution:

when you have changed THE PIn code, write down A new pin code in column of the pin code no.. memo on page 76, and keep it securely.. If you forget your pin code,the projector can no longer be started..

Lamp counter

This function is used to reset the lamp counter.

When the lamp life reaches a recommended lamp replacement

time, the time shown in the dialog box turns red and the Lamp replacement icon appears on the screen, indicating that the end of lamp life is approaching.

When replacing the projection lamp, reset the lamp counter. See “Resetting the Lamp Counter” on page 60.

✔Note:

•The Lamp replacement icon will not appear when the Display function is set to “Off” (p.48), during “Freeze” (p.28), or “Blank” (p.29).

Enter a PIN code

After a correct Logo PIN code is entered, the following dialog box appears.

Change the PIN code lock setting

Use the Point 7 8 buttons to switch between the options.

Change the PIN code

NOTE:

If you forget your PIN code and unable to change it, the PIN code can be reset to the factory default setting (1234) according to the following procedures.

When you reset the PIN code, the Logo PIN code and Key lock will be reset, as well.

1.Unplug the AC Power Cord from the AC outlet.

2.Hold down the OK button on the projector and connect the AC Power Cord into the outlet again. Keep holding down the OK button until the POWER indicator lights. The PIN code returns to the factory default setting while the PIN code lock state will remain the same as the previous set state.

This icon appears on the screen when the end of lamp life is approaching.

✔Note:

•This icon also appears at turning on and selecting input source.