Maintenance and Care
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Filter cover
Top Panel
Lamp cover
Lamp replacement icon
LAMP REPLACE indicator
✔Note:
•The Lamp replacement icon will not appear when the Display function is set to “Off” (p.48), during “Freeze” (p.28), or “Blank” (p.29).
Follow these steps to replace the lamp.
1 | Turn off the projector and unplug the AC power cord. Let |
the projector cool for at least 45 minutes. | |
2 | Open the filter cover. (p.57) |
3 | Loosen the screw and open the lamp cover. Pull out the |
lamp by using the built in handle. | |
4 | Replace the lamp with a new one. Make sure that the |
lamp is properly and fully inserted. | |
5 | Close the lamp cover and secure the screw. |
6 | Close the filter cover. |
7 | Connect the AC power cord to the projector and turn on |
| the projector. |
8 | Reset the Lamp counter (p.60) |
✔Note:
•Be sure to insert the lamp in the correct direction.
•Do not reset the Lamp counter when the projection lamp is not replaced.
Screw
Handle
Lamp
CAUTION
Allow a projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury.
59