
Setting
Lamp mode
This function allows you to change the brightness of the screen.
Auto mode . . . Brightness according to the input signal.
Normal mode . . Normal brightness.
Eco 1 mode . . . Lower brightness and Fan control set to Normal. Lower brightness reduces the lamp power consumption and extends the lamp life.
Eco 2 mode . . . Lower brightness and Fan control set to Max. Lower brightness reduces the lamp power consumption and extends the lamp life. It is recommended to use Eco 2 mode when using the projector continuously over a long period of time. The fan noise becomes louder in Ecot 2 mode than in Eco 1 mode. Select the suitalbe mode for the used environment.
Filter control
You can replace the filter with this function. Press the OK button at Filter control to display a confirmation box. To replace, press the OK button at “YES” and the electrically operated filter starts to scroll.
You can also replace the filter by using the remote control unit (p. 29).
Fan control
Choose the running speed of cooling fans from the following options.
Normal....... Operate in this mode under normal conditions.
Max............ Use this mode when you want to increase the
cooling effect when operating the projector in high ambient temperature environment. Fan noise is lounder than “Normal”.
Remote control
The eight different remote control codes (Code
The same code should set on both the projector and the remote control unit. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control unit:
Press and hold the MENU button and a number button
RC sensor
Select a location of the infrared remote receiver of the remote control unit. See “Remote Control Receivers and Operating Range” on page 15 for details.
Both | Activate both the front and back receiver. |
Front | Activate only the front receiver. |
Back | Activate only the back receiver. |
✔Note:
•Filter replacement icon and “Please wait...” message appear on the screen when the filter is being scrolled.
•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.
Remote control
When pressing the OK button at Remote control unit, the Remote control code menu appears.
51