Delta Electronics DRP024V060W1BA warranty ∙ Output Voltage Adjust, Hold-up Time

Page 10

Switch Mode Power Supply

DRP024V060W1BA

Hold-up Time,

Hold time is the time when the AC input collapses and o/p voltage retains regulation for a certain period of time is called as hold up time. See in the picture below a typical hold up time characteristic of a power supply. The hold time is measured until the output voltage remains in regulation hence it measured until the output voltage reaches minimum regulation -2% of its set value.

∙Output Voltage Adjust

The 24VDC connection is made using the "+" and "–" screw connections. At the time of delivery, the output voltage is 24VDC. The output voltage can be set from 24 to 28VDC on the potentiometer seen as Adjust on the front panel of each power supply.

10/13

Rev: 00,

1/10/2011

 

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DRP024V060W1BA SummaryTechnical Data Status Indicator XX………………….Product Type Block Diagrams/Connections ∙ Derating Curve Both of Horizontal and Vertical Engineering DataModel DRP024V060W1BA Mechanical drawing Device description Fig∙ Overload Protection ∙ Over Temperature Protection∙ Short Circuit Protection Inrush Current ∙ Overvoltage protection∙ Inrush Current, Start-up Time, Output Hold-up Time Start-up Time∙ Output Voltage Adjust Hold-up Time∙ Surge Load ∙ Dynamic Load∙ Redundancy & Parallel Operation with ORing Diode Redundant OperationParallel Operation Step
Top Page Image Contents