Delta Electronics Series E36SR manual LEADED Sn/Pb PROCESS RECOMMEND TEMP. PROFILE, Temp, Time

Page 12
LEADED (Sn/Pb) PROCESS RECOMMEND TEMP. PROFILE

LEADED (Sn/Pb) PROCESS RECOMMEND TEMP. PROFILE

Temperature (°C )

250

200

150

100

50

Ramp-up temp. 0.5~3.0°C /sec.

2nd Ramp-up temp. Peak temp. Pre-heat temp. 1.0~3.0°C /sec. LEAD FREE (SAC) PROCESS RECOMMEND TEMP. PROFILE 210~230°C 5sec.

140~180°C 60~120 sec.

Cooling down rate <3°C /sec.

Over 200°C 40~50sec.

0

60

 

120

180

 

240

 

300

 

 

 

 

 

 

 

Time ( sec. )

 

 

 

 

 

 

Note: The temperature refers to the pin of E36SR, measured on the pin +Vout joint.

LEAD FREE (SAC) PROCESS RECOMMEND TEMP. PROFILE

.

 

 

Temp

Peak Temp. 240 ~ 245

 

 

 

217

 

Ramp down

200

 

max. 4/sec.

 

 

150

Preheat time

 

 

100~140 sec.

Time Limited 90 sec.

 

 

 

Ramp up

above 217

 

 

25

max. 3/sec.

 

 

Time

 

 

Note: The temperature refers to the pin of E36SR, measured on the pin +Vout joint.

DS_E36SR05015_01042008

12

Image 12
Contents DC/DC Power Modules 18~75V in, 5V/15A out Delphi Series E36SR, 75W Eighth Brick FamilyFEATURES OPTIONSTECHNICAL SPECIFICATIONS INPUT CHARACTERISTICSOUTPUT CHARACTERISTICS DYNAMIC CHARACTERISTICSELECTRICAL CHARACTERISTICS CURVES Figure 4 Turn-on transient at full rated load current CC mode current 25%-50% of Io, max di/dt = 0.1A/µs. Load cap 10µF tantalum capacitor and 1µF ceramic capacitor. Top Trace VoutFigure 12 Input reflected ripple current, is, through a 12µH Safety Considerations Soldering and Cleaning ConsiderationsDESIGN CONSIDERATIONS Input Source ImpedanceFEATURES DESCRIPTIONS Over-Current ProtectionOver-Voltage Protection Over-Temperature ProtectionFEATURES DESCRIPTIONS CON Output Voltage Adjustment TRIMRtrim − down = 511Δ − 10.2KΩ Rtrim − up =Thermal Testing Setup THERMAL CONSIDERATIONSTHERMAL CURVES Thermal DeratingPICK AND PLACE LOCATION RECOMMENDED PAD LAYOUT SMDSURFACE-MOUNT TAPE & REEL LEADED Sn/Pb PROCESS RECOMMEND TEMP. PROFILE LEAD FREE SAC PROCESS RECOMMEND TEMP. PROFILETemp TimeMECHANICAL DRAWING Surface-mount moduleThrough-hole module NameMECHANICAL DRAWING WITH HEATSPREADER THROUGH-HOLE MODULEPART NUMBERING SYSTEM MODEL LISTWARRANTY MODEL NAME