![](/images/new-backgrounds/1236522/23652255x1.webp)
TROUBLESHOOTING
If you experience problems with your TAD, try the suggestions in this section. If you still have problems, contact your local RadioShack store for assistance.
Problem | Remedy | |
|
| |
|
| |
The incoming message is incom- | Be sure the memory is not full. | |
plete. |
| |
The caller’s message was longer than 60 seconds. | ||
| ||
|
| |
| The caller was silent for over 8 seconds. | |
|
| |
The incoming message is unclear. | Be sure VOLUME is set to the desired sound level. | |
|
| |
The TAD does not answer after two, | Be sure the TAD is set to answer calls. | |
four, or seven rings. |
| |
|
| |
Lo flashes on the display. | The backup battery is weak. Replace the battery (see | |
| “Installing the Backup Battery” on Page 7). | |
|
| |
The TAD does not respond to the | Make sure the phone you used to dial the TAD is a | |
remote operation security code. | ||
|
| |
| ||
| each button for 2 seconds. | |
|
| |
| The remote operation security code might have reset to | |
| the default code due to a power failure. Make sure the | |
| remote operation security code you entered is correct. | |
|
| |
No messages appear on the display. | This could be caused by a power failure. Reset the TAD. | |
|
| |
You cannot record an incoming | Be sure the TAD is set to answer calls. | |
message. |
| |
Be sure the memory is not full. | ||
| ||
|
|
RESETTING THE TAD
If your TAD stops working properly, remove the AC adapter and the battery from the TAD, then reinstall them.
Note: The outgoing messages and all information stored in memory are erased when you reset the TAD.
28
28