Compaq 3134 manual Installing the Adapter in a Server, Installing the adapter in a server

Page 17

2-4Compaq NC3134 Fast Ethernet Server Adapter User Guide

Installing the Adapter in a Server

Refer to the Compaq ProLiant™ documentation for the specific steps necessary to safely install a PCI card in your server.

Figure 2-2. Installing the adapter in a server

1.If you have not already done so, and if the server is not PCI Hot Plug compliant, power down the server and unplug the power cord.

2.Remove both the server cover and the cover bracket from a PCI slot.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them.

CAUTION: If the server is not PCI Hot Plug compliant, power it down and unplug the power cord from the power outlet before removing the server cover. Failure to do so may damage the adapter or server.

3.Firmly seat the adapter in a PCI slot and secure the adapter bracket.

4.Replace the server cover and plug in the power cord.

Image 17

Contents NC3134 Fast Ethernet Server Adapter Page Contents Appendix B About This Guide Symbols in TextDownload the drivers, firmware, or documentation as needed Where to Go for Additional HelpCompaq Technician Notes PaqFax Number Compaq Customer SupportCompaq Website Calling the Compaq Support Line Worldwide AccessNorth America Europe, the Middle East, and AfricaOverview Introduction2Compaq NC3134 Fast Ethernet Server Adapter User Guide NC3134 AdapterNC7132 Upgrade Module Upgrade ModulesNC3135 Upgrade Module NC3134 and NC3135 LED Indicators LED Indicator DescriptionsNC3133, NC6132, and NC6133 Fiber Upgrade Modules NC7132 LED Indicators UTP and Fiber Cable SpecificationsNC7132 Gigabit Upgrade Module LED Indicators Fiber Upgrade Module LED IndicatorsElectrostatic Discharge Precautions Installing the Upgrade Module AdapterRemoving the Adapter from a Server Attaching the Upgrade ModuleInstalling the Upgrade Module on the Adapter Installing the Upgrade Module and Adapter Installing the adapter in a server Installing the Adapter in a ServerConnecting UTP Network Cable Connecting the Network CableConnecting Fiber Network Cable UTP Network Cable TypesRJ-45 Loop-Back Plug Connecting and Using Loop-Back PlugsClass a Equipment Regulatory Compliance NoticesFederal Communications Commission Notice Modifications Class B EquipmentChina Taiwan Notice Canadian Notice Avis CanadienEuropean Union Notice Japanese Notice Grounding Methods Electrostatic DischargeNC3134 Fast Ethernet Server Adapter Specifications SpecificationsNC3135 10/100 Upgrade Module Upgrade Module SpecificationsNC3132 10/100 Upgrade Module NC3133 100BASE-FX Upgrade Module NC6132 1000BASE-SX Upgrade ModuleNC6133 1000BASE-LX Upgrade Module NC7132 1000BASE-T Gigabit over Copper Upgrade Module UTP Cable SpecificationsTable C-7 NC7132 Gigabit over Copper Upgrade Module Table C-8 UTP Cable Specifications10/100 Straight-Through Pinouts RJ-45 Pinouts and Crossover FunctionGigabit over Copper Internal Straight-Through Pinouts Table C-10 10/100 Pinouts Using External Crossover10/100 Crossover Pinouts Specifications C-7 Table C-12 Gigabit over Copper Crossover Pinouts Gigabit over Copper External Crossover PinoutsFiber Cable Specifications