Listening to AM and FM Radio
1.Turn on your Universal
2.Press the [PORT] remote mode button on your remote controller to select the PORT remote mode.
3. Press the Play [ | ] button repeatedly to |
select AM or FM. |
|
4.Press the [PLAY MODE] button repeatedly to select Auto or Manual Tuning mode.
•Auto Tuning Mode
The AUTO indicator appears and stereo radio reception is possible.
•Manual Tuning Mode
The AUTO indicator disappears and radio recep- tion will be in mono.
5.Use the [
]/[
] buttons to tune into a
station.
In Auto Tuning mode, once a station is found, tun- ing stops automatically.
FM frequency changes in 0.2 MHz steps, 10 kHz steps for AM.
In Manual Tuning mode, the frequency stops changing when you release the buttons. Press the buttons repeatedly to change the frequency one step at a time.
When tuned into a station, the Tuned indicator on your Universal
When tuned into a stereo FM station, the FM STE- REO indicator on your Universal
The FM STEREO indicator shows the status of ana- log audio. (It does not indicate the status during digital reception.)
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the sta- tion in mono.