Christie Digital Systems 38-VIV202-01 Turning on / OFF Projector, Turning on the Projector

BEFORE OPERATION

TURNING ON / OFF PROJECTOR

TURNING ON THE PROJECTOR

1	Complete peripheral connections (with Computer, VCR, etc.)
	before turning on projector. (Refer to "CONNECTING TO
	PROJECTOR" on pages 11~13 for connecting that equipment.)
2	Connect the projector's AC Power Cord into an AC outlet. LAMP
	Indicator lights RED, and READY Indicator lights GREEN.
	NOTE : When “On start” function is ON, this projector is turned
	on automatically by connecting AC Power Cord to an
	AC outlet. (Refer to pages 35, 36.)
3	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit to ON. LAMP Indicator dims, and Cooling Fans

start to operate. Preparation Display appears on the screen and the count-down starts. The signal from PC or Video source appears after 30 seconds.

30

Preparation Display disappears after 30 seconds.

TURNING OFF THE PROJECTOR

1	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit, and a message "Power off?" appears on a screen.
2	Press POWER ON-OFF button again to turn off projector. LAMP
	Indicator lights bright and READY Indicator turns off. After
	projector is turned off, Cooling Fans operate (for 90 seconds).
	During this "Cooling Down" period, this appliance can not be
	turned on.
3	When projector has cooled down, READY Indicator lights
	GREEN again and you can turn projector on. After cooling down

completely, disconnect AC Power Cord from the AC outlet.

TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

Power off?

The message disappears after 4 seconds.

When “Power Management” function is ON, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power Management” on pages 35 and 36.

When WARNING TEMP. Indicator flashes red, projector is automatically turned off. Wait at least 5 minutes before turning on projector again.

When WARNING TEMP. Indicator continues to flash, follow procedures below:

1.Press POWER ON-OFF button to turn the projector off and disconnect AC Power Cord from an AC outlet.

2.Check Air Filters for dust accumulation.

3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 38.)

4.Turn the projector on again.

If WARNING TEMP. Indicator should still continue to flash, contact sales dealer where you purchased this projector or service center.

19