Draper Video Projector VIC12 Kit Installation Instructions, ➀ Close the door to the Revelation

220 V Revelation by DRAPER

VIC12 Kit Installation Instructions

Page 8 of 8

The VIC 12 KIT includes all the components necessary for the VIC 12 to work with the Revelation. Follow these steps to install the components in this KIT.

➀Close the door to the Revelation.

➁DISCONNECT POWER TO THE REVELATION.

➂Remove the covers from the electrical enclosure.

➃Attach the pre-wired limit switch [1] to the shaft mounting bracket which is closest to the motor as shown in FIGURE #1. Using the

#6–32 x 1" [2] long screws and #6 lock washers [2] provided.

➄Run the wires through the open grommet in the end of the electrical enclosure that is toward the motor as shown in FIGURE #1 and connect them as follows:

Connect the black wire to screw #1 of TB2

Connect the blue wire to screw #2 of TB2. (Be sure that wires do not interfere with moving linkage or the sliding inner pan)

➅Put the 12V ACTIVATOR LEVER [3] onto the shaft as shown in Figure #2. The 12V ACTUATOR LEVER will need to be spread out before it will fi t onto the shaft. The door to the Revelation must be closed before going on to step #7

➆Position the 12V ACTUATOR LEVER by rotating it into the limit switch until the limit switch clicks and secure the lever onto the shaft using the #10-32 screw [4] and lock washer [5] supplied with the lever. (Be sure that the screw on the lever is tightened so that the lever does not twist on the shaft.)

FIGURE #1

CR 1	TB 2
CR 2	9 10	Motor
C 1	5 6 7 8	Blue
	3 4
	1 2

Black

Pre-wired limit switch

FIGURE #2

12V actuator lever

12V Actuator lever

➇After the VIC 12 [7] is installed with the screen, run the wiring to the Revelation using the cord strain relief [6] and connect to TB1 as shown in the Revelation wiring diagram.

➈Put the covers back on to the electrical enclosure.

➉Reconnect power to the revelation.

Rotate lever until the limit switch clicks. Tighten lever

onto shaft.

Pre-wired limit switch

VIC 12 OR VIC 12 MODIFIED INSTALLATION PART LIST

ITEM #	DESCRIPTION	QTY
1	PRE-WIRED LIMIT SWITCH	1
2	SCREW #6–32 X 1"(25.4mm) LONG	2
	PHIL PAN HD W/ EXT LOCK WASHER
3	12v ACTUATOR LEVER	1
4	SCREW #10–32 X 3/8" (9.525mm) LONG SHCS	1
5	WASHER #10–.190" I.D. X .375" (9.525mm) O.D.	1
	ZINC INTERNAL TOOTH
6	FITTING CORD CRIMP STRAIN RELIEF	1
7	VIC 12 OR VIC 12 MODIFIED	1

TOOLS NEEDED

MED POINT PHILLIP SCREW DRIVER I/8" FLAT BLADE SCREW DRIVER 3/16" ALLEN WRENCH

www.draperinc.com (765) 987-7999