Desa CF26PR Installing Logs, Installing Wireless Remote Control Accessory, Installation

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

Place one-piece log set on grate to fit as illustrated in Figure 25. Make sure back section of log set is seated into “U”-shaped cutout in center of chassis (see Figure 25). IMPORTANT: Make sure log does not cover any burner ports (see Figure 26).

One Piece Log Set

Burner

Burner	One Piece Log Set
Ports

Figure 26 - Installing One-Piece Log set (Top View)

OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORIES

(CGHRC & CGHRCT Series)

Installing Receiver

1.Disconnect switch wires from the con- trol valve.

2.Remove screws and nuts.

3.Remove switch plate (see Figure 27). Discard after removing.

4.Install remote receiver unit onto gas log heater base using clips (2) and insulat- ing washers provided.

5.Push clips firmly into place (see Fig- ure 28).

6.Connect wires as shown in Figure 29.

Front

Screw

Back

Back

Nut

Nut Wires

Figure 27 - Switch Plate and Wiring Harness (Switch Plate and Orientation May Vary Depending On Model)

Front

Mounting

Clips

Back

Remote

Receiver

Insulating Washers

Figure 28 - Installing Remote Receiver

Valve

White Wire

From Receiver

Red Wire From

Receiver

Figure 29 - Connecting Wires

INSTALLING WIRELESS REMOTE CONTROL ACCESSORY

Two 9-volt alkaline batteries (not included) are required to operate this heater with the wireless hand held remote control set. One battery must be installed in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Receiver

"U"-shaped

Chassis Cutout in Chassis

Figure 25 - Installing One-Piece Log Set

9-Volt Battery

Terminal

Wires

Battery

Clip

Figure 30 - Installing Receiver on the

Back of the Base

Continued

105442 15 For more information, visit www.desatech.com