OWNER’S MANUAL
INSTALLATION
Continued
MANTEL CLEARANCES FOR BUILT-IN INSTALLATION
NOTICE: Surface temperatures of adjacent walls and mantels be- come hot during operation. Walls and mantels above the firebox may become hot to the touch. If installed properly, these tempera- tures meet the requirement of the national product standard. Fol- low all minimum clearances shown in this manual.
If placing mantel above
NOTICE: If your installation does not meet the minimum clearances shown, you must do one of the following:
•raise the mantel to an accept- able height
•remove the mantel
Note: All vertical |
| Mantel Shelf | |||
10" |
|
|
|
| |
measurements |
|
|
|
| |
are from top of | 8" |
|
|
|
|
|
|
|
| ||
fireplace | 6" |
|
|
|
|
opening to |
|
|
|
| |
2 1/2" |
|
|
|
| |
bottom of |
|
|
|
| |
mantel shelf. |
|
|
|
|
|
Minimum Non- |
|
|
|
|
|
Combustible |
|
|
|
|
|
Material | 13" | 16" | 19" | 21" |
|
|
| ||||
|
|
|
|
|
|
Figure 8 - Minimum Mantel Clearances for
REMOVING BRICK LINER RETAINER
1.Using Phillips screw driver, remove 2 screws attaching brick liner retainers to vertical sides.
2.Remove brick liner retainers and discard. Replace 2 screws into vertical sides.
ASSEMBLING BRASS TRIM
(Brass trim shipped with mantel)
1.Remove packaging from three pieces of brass trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 9.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 9).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 9).
6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set brass assembly aside for later installation.
| Slot | Top | |
Set Screws | Brass | ||
| |||
|
| Trim | |
| Shim | Mitered | |
| Edge | ||
|
| ||
Adjusting |
| Side | |
Plate |
| ||
| Brass | ||
Slot |
| ||
| Trim | ||
|
|
Figure 9 - Assembling Brass Trim
OPTIONAL MANTEL
INSTALLATION
Note: Refer to instructions provided with the mantel for assembly instructions. Refer to instructions below for system installa- tion. If using blower accessory (see Acces- sories, page 28), see installation instruc- tions on pages 10 and 11.
1.Choose location for fireplace and in- stall gas supply line.
2.Remove screen from fireplace by re- moving screws in each end of screen rod (see Figure 10). Hold screen rod cover while removing five hex head screws underneath hood (see Figure 11). Carefully lift and pull out hood (see Figure 12).
3.Assemble brass trim kit. See Assem- bling Brass Trim, column 2.
Figure 10 - Removing Screen
Hood
Screen
Rod
Cover
Screw
Figure 11 - Removing Hood Screws
Mantel Screw
Location
Figure 12 - Removing Hood
Continued
105442 | 9 | For more information, visit www.desatech.com |
