CF26PR
INSTALLATION
Continued
4.Place brass trim on the shoulder screws located on the side and top of the fireplace. Firmly snap the brass trim over the shoul- der screws on fireplace (see Figure 13).
5.Place mantel base close to wall in de- sired fireplace location.
6.Install gas line. See Connecting To Gas Supply, page 12
7.Carefully place fireplace on mantel base and center left to right. Check for gas leaks. See Checking Gas Connections, page 14.
8.Refer to instructions provided with the mantel for permanent attachment to wall.
9.Slide mantel around fireplace. Be care- ful not to damage wall or mantel.
10.Adjust assembly to remove any gaps. From back side of fireplace, attach two 2" wood screws through base mount- ing blocks attached to bottom sides of mantel into base (see instructions pro- vided with mantel).
11.Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. See Figure 12, page 9, for screw hole location.
INSTALLING BLOWER ASSEMBLY - GA3450T
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improperanddangerousoperation.
CAUTION: Verify proper op- eration after servicing.
Note: If you are using a mantel with your heater, use the following instructions. If your heater is
1.Screen and hood should be removed from fireplace (see page 9). Remove log set and set aside.
2.Install snap bushings found in hardware kit into both holes in rear of blower control shield (see Figure 14).
Blower |
|
Control | Snap |
Shield | Bushing |
3.Make sure the wire harness is firmly connected to the terminals on the blower bracket assembly.
4.Note the wire locations on back of AUTO/OFF/ON switch. Carefully re- move red wire from the AUTO termi- nal and blue wire from the ON termi- nal. Black wire can remain on the middle or OFF terminal (see Figure 15).
5.Carefully disconnect green and white wires from power cord harness at their insulated connectors.
6.In top of the heater cabinet, locate the four mounting holes on the outer cas- ing. Align these four holes with those on the blower bracket assembly. Attach blower bracket assembly to the outer casing with 4 - #10 screws provided (see Figure 15).
7.Route the wire harness through the hole to the left side of heat deflector. Pull wire harness through lower opening to the left of the blower control shield. (see Figure 15).
8.Insert the 4 wire harness into one of the round holes in the rear of the blower con- trol shield and through the rectangular hole in the front of shield (see Figure 15).
Shoulder | Figure 14 - Installing Snap Bushings | ||
Screws | |||
|
| ||
| Blower Bracket | ||
| Assembly |
| |
| Screw |
| |
| Switch |
| |
Assembled |
| Wire Harness | |
|
| ||
Brass Trim |
| Power | |
|
| Cord | |
| Blue | Red | |
|
| ||
| Switch Plate | Wire | |
|
| Harness | |
Blower 
Control
Shield
Shield Cover
Wiring
Routing Hole
Heat Deflector
Figure 15 - Installing Blower Bracket Assembly
For more information, visit www.desatech.com | 10 | 105442 |
