AT&T F160 user manual Getting Started, Removing the Back Cover, Installing the Battery

Models: F160

1 28
Download 28 pages 55.48 Kb
Page 3
Image 3

Table of Contents

 

Chapter 12 – Care and

 

Maintenance

36

General Care

36

Aircraft Safety

37

Hospital Safety

37

General Guidelines

38

Road Safety

39

Vehicles Equipped with an Airbag

39

Third-Party Equipment

39

Emergency Service

40

Privacy Information

40

Turn on the HAC Setting

40

Copyright Notice

41

2

Chapter 13 – Troubleshooting

 

and FAQs

42

Chapter 14

– Specifications

45

Chapter 15

– FCC Compliance

46

Chapter 16

– Radio Frequency (RF)

 

Energy

49

Getting Started

Note: In this User Manual, “press a key” means to press the key and release it, while “hold a key” means to press the key for at least two seconds and then release it.

Removing the Back Cover

1.Hold the Power/End Key to turn off the phone.

2.Lift the bottom of the back cover from the notch and remove the back cover as shown below.

Battery

Installing the Battery

Notes:

The phone automatically turns off if the battery power is too low.

If you are not going to use the battery for a long time, remove it from the phone and store it in a cool dry place.

1.Hold the Power/End Key to turn off the phone.

2.Remove the back cover.

3.Carefully insert the battery, making sure the contacts are located against the gold springs of the phone.

4.Push down the battery until it clicks into place.

5.Replace the back cover on the back of the phone.

Caution: Make sure the cover is lined up before pressing it into place. Do not force it. Doing so will damage the back cover.

Removing the Battery

1.Hold the Power/End Key to power off the phone.

2.Remove the back cover.

3.Lift the end of the battery near the bottom of the phone and remove the battery from the phone.

3

Page 3
Image 3
AT&T F160 user manual Getting Started, Removing the Back Cover, Installing the Battery, Removing the Battery