Setting the User 1/User 2 mode
There are two
1.Press Menu/Exit to open the
2.Go to the PICTURE > Picture Mode menu.
3.Press 
/ 
to select User 1 or User 2.
4.Press 
to highlight Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in the Picture Mode
5.Press 
/ 
to select a picture mode that is closest to your need.
6.Press 
to select a menu item to be changed and adjust the value with 
/ 
. See
7.When all settings have been done, highlight Save Settings and press Mode/Enter to store the settings.
8.The confirmation message "Setting Saved" displays.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some 
/ 
on the projector or remote control.
Adjusting Brightness
The higher the value, the brighter the image. And the lower the setting, the darker the image. Adjust this control so the black areas of the image appear just as black and that detail in the dark areas is visible.
Adjusting Contrast
The higher the value, the greater the contrast. Use this to set the peak white level after you have previously adjusted the Brightness setting to suit your selected input and viewing environment.
|
| 30 |
|
| 50 |
|
| 70 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 0 |
|
| 30 |
34 Operation