BenQ PB6210 user manual Operation, Startup

Page 22

Operation

Startup

1.Switch all of the connected equipment on.

2.Plug the power cord into the projector and into a wall socket.

Ex.

3.Turn on the wall socket switch (where fitted).

4.Press and hold Power on the remote control or projector to start the unit. The Power indicator light flashes green and stays green when the power is turned on.

5.The start up procedure takes about 30 seconds after pressing Power. In the later stage of start up, a default BenQ logo appears.

6.Then, the projector starts to search for input signals. Irrespective of selected input source, the screen shows the selected source information at the bottom right corner of the screen. If there is no input source detected, the three messages will be displayed on the screen continuously: “RGB/YPbPr Searching”, “Video Searching” and “S-Video Searching”.

7.You can also press Source on the projector or remote control to select your desired input signal. For more information, please refer to page 21.

If the frequency/ resolution of the input signal exceeds the projector’s operating range, you will see the message “Out of Range” displayed on a blank screen.

18 Operation

Image 22

Contents Welcome Copyright DisclaimerTable of Contents Limited Warranty Menu OperationImportant Safety Instructions Refer servicing to qualified service personnelSafety Instructions Allow at least 50 cm clearance from walls Safety Instructions Projector Features IntroductionShipping Contents Front / Upper Side Optional AccessoriesProjector Exterior View Rear SideConnector Panel Controls and Functions External Control PanelRemote Control Description Functions DescriptionsRemote Control Effective Range Installing or Replacing the BatteryConnection Connecting to a Laptop or Desktop ComputerAudio cable Connecting Video and S-Video Devices Connecting Equipment to the Component Video InputAV equipment Connecting to Display Devices Video devices Audio cable Video cableInstallation Choosing a LocationAdjusting the Height Screen SizePB6110 Svga / PB6210 XGA screen size chart 43 aspect ratio Operation StartupDisconnect the power cord from the wall socket ShutdownDigital Keystone Correction For exampleAuto Adjustment Source SelectionBlank Zoom / FocusingSlide Operation Preset Mode Selection FreezeMenu Operation Menu SystemIng 3 Left / Right 4 on Using the MenusOr 6/ 5 on the remote control to select Picture menuKeystone Preset ModePicture Menu BrightnessColor TintPro-Picture Menu Reset Setting MenuVolume OSD Time MuteAdvance Menu High Altitude Mode Source ResolutionInformation Menu Lamp HourCleaning the Projector Case MaintenanceCleaning the Lens Storing the ProjectorReplacing the Lamp Lamp InformationMessage Status Maintenance Resetting the lamp counter IndicatorsLight Status & Description Power Temp Lamp Power events Temp InformationLight Status & Description Power Temp Lamp Lamp events Thermal eventsOptional Accessories not included in the standard package Service InformationAccessories included in the standard package Ordering Parts or Getting InformationTroubleshooting Cause RemedyElectrical GeneralOptical MechanicalSupported Timing for Component-YPbPrInput Timing ChartSupported Timing for PC Input Supported Timing for Video and S-Video InputsDimensions Warranty Limited WarrantyEEC Statement Regulation StatementsFCC Statement MIC Statement