BenQ PE8700 user manual Environment Menu, Installation Menu

BenQ PE8700 User’s Manual

■THROUGH : One-to-one mapping is performed without any scaling of the image, The image is displayed at the center of the screen.

Inactive area

3.PC&HDTV: The following settings are only available with a PC or DTV RGB signal:

■AUTO: Adjusts the phase, frequency and position automatically.

■FREQ.: Adjusts the frequency of the input signal.

■PHASE: Adjusts the phase of the input signal.

■H. POS.: Adjusts the horizontal position of the image.

■V. POS.: Adjusts the vertical position of image.

4.SAVE: There are three video memories in which the user can store settings, including all items in the Picture menu.

5.LOAD: Loads the settings from one of three video memories.

ENVIRONMENT Menu

In this menu, global settings for the projector can be made.

There are four items available: DEFAULT — LAMP TIMER — AUTO OFF — LAMP HOURS.

1.DEFAULT: Loads the default value of the current input source.

2.LAMP TIMER: Resets the lamp timer. This should only be done after the lamp has been replaced.

3.AUTO OFF: Sets the auto-shutdown timer. The timer can be set to a value between10 minutes and 3 hours.

4.LAMP HOURS: This displays the number of hours the lamp has been used. (The lifetime of the lamp is 2000 hours.) If lamp usage exceeds 2000 hours, a warning message will be displayed on-screen; when this happens, contact your BenQ dealer for a new lamp.

INSTALLATION Menu

This menu contains items necessary for installation.

225. Menus