Acer T111E, T121E, S5301WB, S5201B, PS-X11K, PS-W11K Reset, LAN Setting, For P5206, N216/PN-X14

29

Reset	Press	after choosing "Yes" to return the display
	parameters on all menus to the factory default settings.

To connect your projector to the network:

1Take a RJ45 cable and connect one end to the LAN input jack of the projector and the other end to the RJ45 port.

2Enter the LAN Setting menu. The "Enter Administrator Password" dialogue box is displayed.

3Enter "Administrator Password". The next level menu is displayed.

The factory default of "Administrator Password" is "1234". You can change it in the Setting > Security > Administrator Password menu.

	4	Select LAN in this menu and press		to select "On".
	5	Make sure DHCP is on, and press		to select Apply and
LAN Setting		press	.
	6	Re-enter the menu and note down the IP address
(for P5206/		displayed in the row of Projector IP Address.
N216/PN-X14/
S5201/T111/PS- If your are not in a DHCP environment, set DHCP to "Off" and
X11)	contact your ITS administrator for information on Projector IP
	Address, Subnet Mask, Default Gateway, and DNS Server.

1 Press to select Projector IP Address and press .

2 Press	to move the cursor and press	to
enter the digits.

3When you finish, press MENU to save and exit the menu.

4Repeat steps 1-3 to input addresses for Subnet Mask, Default Gateway, DNS server.

5Press to highlight Apply and press .

To control the projector remotely:

1Enter the Projector IP address in the address bar of the web browser on your computer.

2The remote network operation page is displayed.You can control the projector by using this page. For details, see the notes following this table.

LAN Reset	Press	after choosing "Yes" to return all items on the Tools
(for P5206/	page to the default settings.
N216/PN-X14/
S5201/T111/PS-
X11)

English