Acer S5301WB, N216, T121E, S5201B, T111E, PS-X11K Problems with the Projector, Condition Solution

36

English	8	Image is stretched	When you play a DVD encoded in anamorphic or 16:9
		when displaying a	aspect ratio you may need to adjust the following
		"widescreen"	settings:
		DVD title	•	If you play a 4:3 format DVD title, please change the
				format to 4:3 with the projector OSD.
			•	If the image is still stretched, you will also need to
				adjust the aspect ratio. Set up the display format to
				16:9 (wide) aspect ratio on your DVD player.
	9	Image is too small	•	Adjust the zoom lever on the top of the projector.
		or too large	•	Move the projector closer to or further from the
				screen.
			•	Press "MENU" on the control panel or remote
				control. Go to "Image > Aspect Ratio" and try
				different settings.
	10	Image has slanted	•	If possible, reposition the projector so that it is
		sides		centered on the screen and below the bottom of the
				screen.
			•	Press the Keystone correction keys on the control
				panel or remote control until the image becomes
				square.
			•	Press "MENU" on the control panel or remote
				control to open the OSD menu. Go to "Image > Auto
				Keystone" or "Image > Manual Keystone" to make
				adjustments.
	11	Image is reversed	•	Select "Image > Projection" on the OSD and adjust
				the projection direction.
	Problems with the Projector
	#	Condition			Solution
	1	The projector stops responding			If possible, turn off the projector, then
		to all controls			unplug the power cord and wait at least 30
					seconds before reconnecting power.
	2	Lamp burns out or makes a			When the lamp reaches the end of its useful
		popping sound			life, it will burn out and may make a loud
					popping sound. If this happens, the projector
					will not turn on until the lamp module has
					been replaced. To replace the lamp, follow
					the procedures in the "Replacing the Lamp"
					section.