Acer 65PE specifications Operation, Power on, Standby, Control Pad

Page 13

Operation

3

 

 

 

Turn On/Off Procedure

A Power on

Press the Standby/On key to turn on the lamp. The LED will blink green during warm up and then light solid green.

"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be displayed on the screen after the projector has identified the input signal;

“SEARCHING“ message will be displayed on the screen if there is no signal input;

“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal frequency of the input signal exceeds the range of the projector.

B Standby

Press the Standby/On key for more than one second to turn off the lamp. The LED will then blink orange and the lamp will shut down, but the fan will continue to run for about 1 minute to cool the lamp. After the fan stops, the LED will turn to a light solid orange.

*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector will ignore the command until it has cooled down for one minutes.

External Control

AControl Pad

Figure 12 External control pad

English 9

Image 13
Contents PalmPro 7763P/65PE Fill this English Table of Contents Introduction AV box Ceiling Mount and Rear Screen ProjectionDescription Front figureBottom figure InstallationPositioning Moving the Projector Adjustable FeetMoving the projector AccessoriesAccessories of 7763P/65PE Connection Connecting the Projector to Computer/NotebookConnection to Macintosh Connecting the Projector to Macintosh/Power BookOperation Power onStandby Control PadIndicator Indicator StatusMenu ExitRemote Control Light source lamp has a limited service life Usage and Replacement of LampLamp in excess of service hours Lamp/temperature Status LED IndicatorReplacing the Lamp Temperature is too highLamp is not well attached Normal statusEnglish Step Lamp Replacement ProcedureMain OSD Menu Resetting Lamp TimerDisplay Image Image Ratio ControlTint Source Blank Auto Off ResetOther Correspondent Remote Functions and Messages English Lamp Replacement Maintenance TroubleshootingCleaning the Lens TroubleshootingPress Volume + button Adjust audio sourceStand within 4 meters 13 feet of the unit Make sure nothing is blocking the receiver onOptical Specifications5Electrical Mechanical70.1 Preset Display Resolution TableVolume Down Volume upAppendix AV Connection PortPlease follow the instruction here to place the AV box Connecting the Box