Acer 65PE specifications Lamp/temperature Status LED Indicator, Lamp in excess of service hours

Page 17

The picture will become dark or the color will fade after the lamp has been used for a long time. In such cases, continued use of the lamp could cause a malfunction. Replace the lamp with a new one.

A Lamp/temperature Status LED Indicator

1.Lamp in excess of service hours

When the LED light is a continuous red, it means the lamp has exceeded (*1500) service hours. After this light appears, it is advisable to replace the projection lamp as soon as possible.

i.“CHANGE THE LAMP, AND RESET THE LAMP TIMER” will be displayed on the screen if the lamp has been operated for 1200 hours (see figure 16).

ii.“CHANGE THE LAMP, THE POWER WILL TURN OFF AFTER 20 HOURS” will be displayed on the screen if the lamp has been operated for 1479 hours. The “20” will count down (see figure 17).

iii.“CHANGE THE LAMP!” will blink on the screen together with a red LED if the lamp has been operated for more than (*1500) hours (see figure 18). The power will turn off automatically after 10 minutes. All three of the above messages will not display for more than 3 minutes, but each message will be displayed whenever you turn on the lamp.

Figure 16 Lamp replacement warning signal

English 13

Image 17
Contents PalmPro 7763P/65PE Fill this English Table of Contents Introduction AV box Ceiling Mount and Rear Screen ProjectionDescription Front figurePositioning InstallationBottom figure Moving the Projector Adjustable FeetMoving the projector AccessoriesAccessories of 7763P/65PE Connection Connecting the Projector to Computer/NotebookConnection to Macintosh Connecting the Projector to Macintosh/Power BookOperation Power onStandby Control PadIndicator Indicator StatusMenu ExitRemote Control Light source lamp has a limited service life Usage and Replacement of LampLamp in excess of service hours Lamp/temperature Status LED IndicatorReplacing the Lamp Temperature is too highLamp is not well attached Normal statusEnglish Step Lamp Replacement ProcedureMain OSD Menu Resetting Lamp TimerDisplay Image Tint ControlImage Ratio Source Blank Auto Off ResetOther Correspondent Remote Functions and Messages English Lamp Replacement Maintenance TroubleshootingCleaning the Lens TroubleshootingPress Volume + button Adjust audio sourceStand within 4 meters 13 feet of the unit Make sure nothing is blocking the receiver onOptical Specifications5Electrical Mechanical70.1 Preset Display Resolution TableVolume Down Volume upAppendix AV Connection PortPlease follow the instruction here to place the AV box Connecting the Box