Acer PD126D series, PD117D series manual Replacing the lamp, Lamp Changing Procedure

Page 41

Appendices

Replacing the lamp

The projector will detect the lamp life itself. It will show you a warning message “Lamp is approaching the end of its useful life in full power operation. Replacement Suggested!” When you see this message, changing the lamp as soon as possible.

Make sure the projector has been cooled down for at least 30 minutes before changing the lamp.

NOTE

Warning: Lamp

compartment is hot! Allow it to cool down before changing lamp!

NOTE

Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.

3

1

2

4

Lamp Changing Procedure:

1.Turn the power off the projector by pressing the “ ” button.

2.Allow the projector to cool down at least 30 minutes.

3.Disconnect the power cord.

4.Use a screwdriver to remove the screw from the cover. 1

5.Push up and remove the cover. 2

6.Remove the 2 screws from the lamp module. 3

7.Pull out the lamp module. 4

To replace the lamp module, reverse the previous steps.

39 ... English

Image 41

Contents Manual for USA Table of Contents Usage Notice PrecautionsDon’t Introduction Product FeaturesHdtv Package OverviewMain Unit Product OverviewControl Panel Connection Ports For PD126D Remote ControlFor PD117D InstallationConnecting the Projector Powering On the Projector Powering On/Off the ProjectorPowering Off the Projector Adjusting the Projector Image Height Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector Zoom / FocusFor PD117D For PD126DUser Controls Control Panel & Remote ControlControl Panel Remote Control Empowering Key Using the Remote Control PowerAcer eTimer Management Acer eView ManagementDown Computer mode only Up Computer mode onlyZoom Keystone +On-Screen Display Menus How to operateDisplay Mode Color Computer / Video ModeColor R DegammaColor G Color BImage Computer Mode Position Vertical Position Position Horizontal PositionFrequency TrackingRear-Desktop Image Video ModeSharpness ECO Mode Management Computer / Video ModeAuto Shutdown Source LockAcer eOpening Management Startup ScreenUser Controls Lamp Hour Elapse Lamp Hour ResetLamp Reminding SecurityTimeoutMin Administrator Password Reset Volume Audio Computer / Video ModePower On/Off Volume Alarm VolumeTimer Computer / Video Mode Language Language Computer / Video ModeProblem No image appears on screen TroubleshootingProblem Partial, scrolling or incorrectly displayed image AppendicesProblem Image is out of focus Problem Image is unstable or flickeringProblem Image has vertical flickering bar Problem Image is reversed Problem The image is outstretched when displaying DVDProblem Lamp burns out or makes a popping sound Problem LED lighting messageProblem Projector automatically turns to standby state Problem Message RemindersTo replace the lamp module, reverse the previous steps Lamp Changing ProcedureReplacing the lamp Specifications Svga Compatibility ModesFCC notice Regulation & safety noticesCompliant with Russian regulatory certification Important safety instructions Appendices