Onkyo HT-R640 Changing the Input Display, TV Format Setup Not North American models

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Onkyo MiniDisc recorder, CD recorder, or next generation HDD-compat- ible component to the TAPE IN/OUT or VIDEO 3 IN

jacks, for to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

1, 2 1, 2

iPod photo: If you’re using an iPod photo with the DS-A1 Remote Interactive Dock, connect the DS-A1 to the VIDEO 3 IN jacks.

1	Press the [TAPE] or [VIDEO 3]
	TAPE
	input selector button so that
	“TAPE” or “VIDEO3” appears on
	the display.
	VIDEO 3

TV Format Setup

(not North American models)

You must specify the TV system used in your area.

1		Press the [RECEIVER] or [AMP]
AMP	RECEIVER	button, followed by the [SETUP]
		button.
		The main menu appears onscreen.

SETUP

2	Use the Up and Down [ ]/[ ]
	buttons to select “7. Hardware
	Setup,” and then press [ENTER].
	The Hardware Setup menu appears.
	7.Hardware Setup
	------------------------
	a.TV Format	:Auto
	b.Remote ID	:1
	c.HDMI Audio Out :Off
	d.SW Input Sensitivity
		: 0dB

3 Use the Up and Down []/[ ]

2 TAPE

VIDEO 3

Press and hold down the [TAPE] or [VIDEO 3] input selector but- ton (about 3 seconds) to change the setting.

Repeat this step to select MD, CDR, or HDD.

For the TAPE input selector, the setting changes in this order:

TAPE → MD → CDR → HDD

→

For the VIDEO 3 input selector, the set- ting changes in this order:

VIDEO 3 ↔ HDD

buttons to select “TV Format,” and then use the Left and Right []/[ ] buttons to select:

Auto: Select this to automatically detect the TV system from the video input signals.

NTSC: Select if the TV system in your area is NTSC.

PAL: Select if the TV system in your area is PAL.

4	Press the [SETUP] button.
	The setup menu closes.
SETUP

Note:

HDD can be selected for the TAPE input selector or VIDEO 3 input selector, but not both at the same time.

Note:

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

44