Onkyo HT-R640 Multichannel DVD Input Settings, Audio Adjust Functions, SW Input Sensitivity

Advanced Setup—Continued

Multichannel DVD Input Settings

1	Press the [RECEIVER] or [AMP]
	button followed by the [SETUP]
AMP RECEIVER	button.
	The main menu appears onscreen.

SETUP

2	Use the Up and Down [	]/[	]
	buttons to select “7. Hardware
	Setup,” and then press [ENTER].
	Use the Up and Down [	]/[	]

buttons to select “SW Input Sen- sitivity,” and use the Left and Right []/[ ] buttons to select a value.

3	Press the [SETUP] button.
	The setup menu closes.

SETUP

SW Input Sensitivity

Some DVD players output the LFE channel from their subwoofer output at 15 dB higher than normal. You can change the subwoofer sensitivity to match your DVD player. Note that this setting only affects signals con- nected to the SUBWOOFER input jack of the multi- channel DVD input.

You can select 0 dB, 5 dB, 10 dB, or 15 dB.

If you find that your subwoofer is too loud, try the 10 dB or 15 dB setting.

Audio Adjust Functions

Here you can set listening mode-related settings and functions.

1	Press the [RECEIVER] or [AMP]
AMP RECEIVER	button followed by the [SETUP]
	button.
	The main menu appears onscreen.

SETUP

2	Use the Up and Down [			]/[	]
	buttons to select “4. Audio
	Adjust,” and then press [ENTER].
	The Audio Adjust menu appears.
	4.Audio Adjust
	------------------------
	a.Multiplex :		Main
	b.Mono Input Ch: L+R
	c.PL	Panorama	:Off
	d.PL	Dimension	: 0
	e.PL	Center Width :3
	f.Neo:6 CenterImage:2
	g.T-D Listening Angle
		: Wide
3	Use the Up and Down [			]/[	]
	buttons to select the settings,
	and use the Left and Right [				]/
	[ ] buttons to set them.
	The settings are explained on page 66.

4	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.
SETUP

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

65