Onkyo HT-R640 Assigning Listening Modes to Input Sources, Use the Input Selector but, Want to set

Advanced Setup—Continued

Assigning Listening Modes to Input Sources

You can assign a default listening mode to each input source that will be selected automatically when you select each input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can select other listening modes dur- ing playback, but the mode specified here will be resumed once the AV receiver has been set to Standby.

1			Press the [RECEIVER] or [AMP]
AMP	RECEIVER		button followed by the [SETUP]
			button.
			The main menu appears onscreen.
SETUP
2			Use the Up and Down [		]/[	]
			buttons to select “5. Input
			Setup,” and then press [ENTER].
			The Input Setup menu appears.
			5.Input Setup
			--------DVD/MCH---------
			a.IntelliVolume: 0dB
			Listening Mode Preset
			b.Ana/PCM:Last Valid
			c.Dolby D:Last Valid
			d.DTS	:Last Valid
			e.D.F.2ch:Last Valid
			f.Mono	:Last Valid
			g.MCH Ana:Last Valid
3			Use the INPUT SELECTOR but-
1	2	3	tons on the remote controller to
			select the input source that you
V1	V2	V3
4		6	want to set.
V4		DVD	For input selectors that have no digital
7	8	9
TAPE	TUNER	CD	input jacks, only “b. Analog” will be
			available.
4			Use the Up and Down [		]/[	]
			buttons to select the signal for-
			mat that you want to set, and
			then use the Left and Right [			]/

[ ] buttons to select a listening mode.

Only listening modes that can be used with each input signal format can be selected.

The Last Valid option means that the listening mode selected last will be used.

b. Ana/PCM: With this setting, you can specify the listening mode to be used when an analog (CD, TV, LD, VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is played. c. Dolby D: With this setting, you can specify the listening mode to be used when a Dolby Digital format digital audio signal is played (DVD, etc.).

d. DTS: With this setting, you can specify the listening mode to be used when a DTS format digital audio signal is played (DVD, LD, CD, etc.).

e. D.F. 2ch: With this setting, you can specify the listening mode to be used when a 2-channel (2/0) digital audio signal (Dolby Digital, DTS) is played (DVD, etc.).

f. Mono: With this setting, you can specify the listening mode to be used when a mono digital audio signal is played (DVD, etc.).

g. MCH Ana: This setting is available only when DVD or MULTI CH is selected with INPUT SELECTOR. With this setting, you can specify the listening mode to be used when the DVD analog multichannel input is used.

h. MCH PCM*: Specifies the default listening mode for multichannel PCM sources input via a HDMI IN, such as DVD-Audio.

i. PCM192k*: Specifies the default lis- tening mode for high resolution

176.4kHz and 192 kHz digital audio sources such as DVD-Audio.

*Only for inputs the HDMI IN jack is assigned to

5	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.
SETUP

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

67