Bosch Appliances 1200 software manual Configuring the system, Disabling Windows Update

1200 and 1400 Series iSCSI Disk ArraysConfiguring the system en 21

3	Configuring the system
		This chapter provides information on preparing the iSCSI device before usage. These tasks
		have already been performed on an iSCSI device that you just have purchased as all Bosch
		DLA disk arrays come pre-installed and pre-configured. But if you change hard disks that were
		not RAID protected on an iSCSI device, you must again perform some of these configuration
		tasks.
3.1	Disabling Windows Update
		To disable Windows Update:
		1. Open Server Manager.
	2.		In the Security Information section, click Configure Updates, click Change Settings and
			click to check Never check for updates.
	3.		Click OK.
3.2	Configuring Windows Firewall for iSCSI Software Target
		You must configure the Windows Firewall to allow the necessary network traffic to pass. The
		following table lists the required ports.
		Port or application		Description
		TCP 3260		Microsoft iSCSI Software Target Service. This port
				provides the primary access to the Microsoft iSCSI
				Software target.
		TCP 135		Remote Procedure Call (RPC), this port is required for
				Component Object Model (COM) communication.
		UDP 138		NetBIOS Datagram Service, this exception should already
				exist for File and Print Service role, but may need to be
				added manually if not present.
		%windir%\System32\Wintarg		Microsoft iSCSI Software Target Service
		et.exe
		%windir%\System32\WTStatu		Microsoft iSCSI Software Target status proxy
		sProxy.exe
		Note

You may receive remote procedure call (RPC) errors when trying to remotely manage a Microsoft iSCSI Software Target if you do not configure the Windows Firewall exception for WTStatusProxy.exe.

The following table contains the Windows Firewall exceptions that should be made on the iSCSI initiator computer.

Application exception	Description
%windir%\System32\Wtvds.exe	The Microsoft iSCSI Software Target VDS Hardware
	Provider

To add an inbound filter rule for a program:

1.Open Windows Firewall with Advanced Security. In Server Manager, expand Configuration, expand Windows Firewall with Advanced Security, and then click Inbound Rules.

2.In the Actions pane, click New Rule.

3.Under What type of rule would you like to create, click Program, and then click Next.

Bosch Sicherheitssysteme GmbH Software Manual Doc V1 2010.09